Hi Darrin! The MORryde RV Cargo Slide Tray - 90" x 23" - 2 Way Slide - 60 Percent Extension - 800 lbs #MR78RV can clear a lip up to 1.57 inches, so call it 1-1/2 inches to be safe. If you need it to be higher, we do also have the Height…
Hey Bob, thanks for reaching out, and good question. For that setup, as long as the tray is properly secured in the portion that is touching the floor, it will be just fine. It might be a bit more difficult to install since you can't secure the…
Hey Ethan. From the mounting point of your RV to the top of the carpeted base is going to be 2.31" on the MORryde RV Cargo Slide Tray item #MR78RV. The bottom of the tray sits 1.57" above the mounting point on your RV and the wooden base is…
Hi Chuck! The MORryde RV Cargo Slide Tray - 72" x 26" - 1 Way Slide - 60 Percent Extension - 800 lbs #MR67FR sits 1.6 inches above the floor you mount it on. If you want or need it to be a bit higher off the floor, you can also grab the…
Hey Tim. The 48" x 23" measurement is the entire MORryde RV Cargo Slide Tray item #MR63ZV. The inside tray dimensions are 46-1/4" long x 19-7/8" wide. The MORryde RV Cargo Slide Tray item #MR63ZV has a 800 lbs capacity and slides…
Hey Richard, I wish there was a way to lock out the MORryde sliding cargo trays like the part #MR76FR in the extended position but that's just not a feature they have. They can lock in the retracted position but not extended. Are you loading…
Good question, Dave. The easiest way is to match the RVpaws kit to your jack leg or leveling system. For example, there are specific kits for the brands and lineups out there: Standard 2" round jack leg = #RV57FR Standard 2" square jack leg…
Hello Clint, thanks for getting in touch. With the Phoenix Electric Trailer Jack #UF38-944040, generally when the unit beeps and does not function properly, it is due to a low voltage situation. The first thing to do will be to check your battery and…
You can go with a listed 29" model of the MORryde RV Cargo Sliding Tray as its actual width is 28-3/4". Please note the attached image showing dimensions of width. We have the #MR69FR that is 90" in length by 29" wide and has a 2…
Hey Jeff! For a replacement I recommend the etrailer Electric Trailer Jack #e23ZV. This is a direct replacement with the same 18" lift and 3,500 lb capacity as your FIC-ETJ3500-LP10. If you want something with a little more power we have the…
Hey Arthur, The dimensions I'm seeing for a 3500watt Predator Generator show it being 22.8" L x 17.3" W x 20" T so if you're wanting it to sit with the 17.3" side facing out the closest fit would be the MORryde RV Cargo…
While there is no visual guide available to determine the sizing for the MORryde sliding cargo trays like the #MR38FR, it really depends on the height, length, and depth of your RV compartments opening. The #MR38FR that you were looking at, for…
Fantastic customer service and very friendly person on the phone. Quick shipment for an item that wasnt even in stock. AAA+++ in my opinion!!!
Steve
Tucson, AZ
RV Cargo Slides with 48 Inch Long, 29 Inch Wide
Tidy up your storage with a 48 inch long, 29 inch wide slide that brings your gear within easy reach. Solid construction and simple installation make it a smart fit for under-bed areas or a single outside compartment, so you're not climbing over totes to grab what you need.
Installation is reported as easy. Dry-fit the tray, square it up, and mark hole locations before drilling. A lot of hardware is typically included for different RV flooring types; select only what suits your floor and fasten securely.
Expect approximately 65lbs weight and an 800lb capacity. Verify your RV floor can support the slide weight plus your cargo. Confirm the capacity rating on the specific unit you choose and secure it using hardware appropriate for your flooring.
It makes gear access much easier by bringing your totes and tools to you. You won't have to reach over items in the middle or unload the front to get a bin in the back. It's a strong upgrade for an outside storage location or under-bed compartment.
Yes, it's described as ideal for 5th wheel slam latch trunks. Measure your trunk opening and depth to confirm the 48" x 29" footprint clears the door and any seals. Check the mounting surface and use hardware that matches your RV flooring; plenty is typically included and not all may be needed.
Filters
