Marine Plumbing

Hey Doug, congratulations on the new truck and trailer! That is a nice setup for sure. Unfortunately, the backup cameras aren't going to integrate with your dash cam system. Since you're already prepped for Furrion, and it is the best on the…

Both the blue/purple 8 inch keel rollers like part #YR800B and the yellow part #YR800Y are essentially the same thing just different colors. These are non-marking style rollers which is the way to go as the black ones will leave marks.

Great question Brandon, so the yellow part #YR500YW-9P and the blue part #YR500BW-9P are both considered non-marking and have great reputations. Mostly people say they are both just as effective as the other so I would feel confident recommending…

The yellow and blue rollers are considered "non-marking" rollers so they are the ones I recommend most. Black ones have a tendency to leave marks on boats so usually don't recommend them. I attached a page that has all of the…

Hello Greg, Thank you for the rotor measurement, it was most helpful as it tells me you have a 2K axle. Tie Down Engineering is no longer, but Kodiak parts work great! The Calipers are different for the driver and passenger side: - Driver Side:…

Hey Timothy, here's the instructions for removing the cable assembly of a Valterra waste valve like the part #VAL54MB: Remove the locknut from the cable housing assembly. Feed the cable through the mounting bracket or hold in the wall of chassis.…

The specs I found for the 2018 Dutchmen Coleman Lantern 263BH tandem axle travel trailer indicate a dry weight of 5871-lbs and a payload capacity of 1729-lbs. Added together these become the GVWR for the trailer, the gross vehicle weight rating, the…

Carlisle and Kenda trailer tires are about the same in terms of quality. We only sell Kenda currently so I'll try not to give you too much bias...but the Kenda Karrier S-Trail ST145/R12 Radial Trailer Tire #AM10130 that you referenced is very…

In regards to the Bristol Double RV Waste Valves part #34466ND13AAR, you can replace both the black valve section using the Bristol Waste Valve Body for RV Black Water part #34439240 and the grey valve section using the Bristol Waste Valve Body for…

Self tapping screws like the part #WLS100 which has a Torx head or a part #FA1131822 which is a hex head style bolt would work well. We don't normally see people seal the lights to the trailer as most light assemblies are a weather proof or…

Hey Bladen, is it possible to use a slightly longer cable? We don't have 36 inch but we do have a 48 cable for a Valterra valve with the part #VAL64GB.

When you test the 4-Way on the Curt T-Connector Wiring Harness, part #56016, at the rear of your vehicle, it should show now power on all 3 pins with the lights off. If you have the vehicle head lights on, you should have around 12 volts at the brown…

Hey Doug, congratulations on the new truck and trailer! That is a nice setup for sure. Unfortunately, the backup cameras aren't going to integrate with your dash cam system. Since you're already prepped for Furrion, and it is the best on the…

Both the blue/purple 8 inch keel rollers like part #YR800B and the yellow part #YR800Y are essentially the same thing just different colors. These are non-marking style rollers which is the way to go as the black ones will leave marks.

Great question Brandon, so the yellow part #YR500YW-9P and the blue part #YR500BW-9P are both considered non-marking and have great reputations. Mostly people say they are both just as effective as the other so I would feel confident recommending…

The yellow and blue rollers are considered "non-marking" rollers so they are the ones I recommend most. Black ones have a tendency to leave marks on boats so usually don't recommend them. I attached a page that has all of the…

Hello Greg, Thank you for the rotor measurement, it was most helpful as it tells me you have a 2K axle. Tie Down Engineering is no longer, but Kodiak parts work great! The Calipers are different for the driver and passenger side: - Driver Side:…

Hey Timothy, here's the instructions for removing the cable assembly of a Valterra waste valve like the part #VAL54MB: Remove the locknut from the cable housing assembly. Feed the cable through the mounting bracket or hold in the wall of chassis.…

The specs I found for the 2018 Dutchmen Coleman Lantern 263BH tandem axle travel trailer indicate a dry weight of 5871-lbs and a payload capacity of 1729-lbs. Added together these become the GVWR for the trailer, the gross vehicle weight rating, the…

Carlisle and Kenda trailer tires are about the same in terms of quality. We only sell Kenda currently so I'll try not to give you too much bias...but the Kenda Karrier S-Trail ST145/R12 Radial Trailer Tire #AM10130 that you referenced is very…

In regards to the Bristol Double RV Waste Valves part #34466ND13AAR, you can replace both the black valve section using the Bristol Waste Valve Body for RV Black Water part #34439240 and the grey valve section using the Bristol Waste Valve Body for…

Self tapping screws like the part #WLS100 which has a Torx head or a part #FA1131822 which is a hex head style bolt would work well. We don't normally see people seal the lights to the trailer as most light assemblies are a weather proof or…

Hey Bladen, is it possible to use a slightly longer cable? We don't have 36 inch but we do have a 48 cable for a Valterra valve with the part #VAL64GB.

When you test the 4-Way on the Curt T-Connector Wiring Harness, part #56016, at the rear of your vehicle, it should show now power on all 3 pins with the lights off. If you have the vehicle head lights on, you should have around 12 volts at the brown…