The issue you most likely ran into is that winches draw way more amperage than what the 12 volt accessory wire of your 7-way can provide. You would have needed something like the part #BDW20207 to power your winch. Your going to have to start…

Thanks for reaching out, Lee! I recommend installing the Firestone Ride-Rite Air Helper Springs #F22ZR on your 2019 Ford E-450 Class C motorhome because the Firestone air bags are the best on the market and this is the only kit that fits your…

The difference between an load range C and load range D tire in the same size is the capacity and psi rating. The two tires will still have the same dimensions and fit on the same wheel. The D rated tire has a higher capacity. For a ST175/80D13…

To determine the size of the hub assembly you need to purchase you have to determine which bearings are in the old assembly. If the old assembly has L44649 inner bearings, you would use the hub you chose #8-258-5UC1. If the inner bearings are…

Hey Rob; thanks for the photos and it was actually the one with the hub number that did it. That's a BD 545 which is an AxleTek 3,500 lb hub and drum like the Trailer Hub and Drum Assembly #AKHD-545-35-K. The 35 on the axle sticker was a…

It appears the additional wire was added to the Transom Saver #315-FXH was to ensure the trailer side of the transom saver does not fall off the trailer. The motor side of the transom saver typically uses a Rubber Strap #TCTS15 to ensure this side…

We do have a great option for replacing your Tie Down LP 750 Brake Actuator. The Dexter DX7.5L A-60 Brake Actuator #DX29FR that you mentioned can be used for a lot of different trailer tongue configurations. It can be slid inside a trailer tongue…

Yes, the Timbken bearings part #TMK73VR and #TMK23VR are made in the USA.

The reverse light pin on a traditional 7-way trailer connector, like part #PK11893 or a factory connector if that's what you have on your 2018 Ram, is the center pin. Take a look at the picture I attached that shows all the pin functions. To…

You are correct that the issue is on your trailer and based on what you are describing the circuits are somehow swapped when you installed your connector; unfortunately, I was unable to find your order number to see what you purchased from us for…

Honestly, I would recommend you stick with the winch that came with the Neumann Boat Lift that you have. It was designed and tested for being used with your application and the only better alternative I would recommend would be to go with an…

We do have a potential solution for you, but the Replacement Inner Member #DX99FR is not a suitable replacement for the TDE 8000LP. The #DX99FR is made only for Dexter DX7.5L and Legacy UFP actuators. The pins will not line up with a TDE I am sorry…