Filter by Application
Videos
for Boat Bumpers
Help Articles
for Boat Bumpers
Expert Answers
for Boat Bumpers
Hi Len! I had not noticed that before. I asked and Curt does indeed integrate the ground into the plug in connection on a lot of their wiring harnesses and the #C53VV T-Connector is one of them. Tekonsha almost always has a separate ground that needs…
view full answer...Hey Bill, so if it was me I would go with the Dutton Lainson winch part #DL17085 over the Fulton. I really like DL winches because they are well made, very reliable, and made in the USA. Fulton winches aren't terrible but DL winches win if for…
view full answer...Hey Paul, the Replacement Vacuum Breaker Kit #DOM95FR that you referenced is the correct vacuum breaker kit for your Dometic 310 Part Timer toilet. How old is your toilet?
view full answer...Hey John! Yes, the Easy Grease Trailer Idler Hub Assembly for 2K Axles #AKIHUB-440-2-G-EZ-1K looks to be exactly what you're needing! What boat trailer do you have?
view full answer...To remove or install the Railing Foot #753-2157-02 from the cross bar you need to push in the gray latch and slide down the black cover identified by the red arrow in the picture attached. This will allow you access to the allen head bolt to loosen…
view full answer...For the 2019 Ford F-350 with the factory puck system, the correct B&W Companion OEM Slider 5th Wheel Hitch is the part #BWRVK3370. With the hitch mounted, the rear of the base will sit exactly 8-11/32" back from the front pucks up towards…
view full answer...I recommend the Kenda Karrier S-Trail ST145/R12 Radial Trailer Tire - Load Range E #AM10140 and the Aluminum Lynx Trailer Wheel - 12" x 4" Rim - 5 on 4-1/2 - Silver #LH45FR for Triton Jet Ski trailer. This aluminum wheel will stand up well…
view full answer...Hey Ed, thanks for the information. The only 2-1/2" extensions I have are going to be quite a bit longer than 12" but I have two possible solutions. The Curt Hitch Extension and Reducer for 2-1/2" Trailer Hitches item #C45048 is going…
view full answer...Hey Harry, welcome back! The Replacement Bearing Buddy Bras item #BB19B are what you'll need for a Bearing Buddy with a 2-1/8" outer diameter. This bra fits about a half dozen Bearing Buddy Protectors. The closest Bearing Buddy Bearing…
view full answer...On your 2010 Ford Explorer Sport Trac the factory plug for your brake controller will be located under the dash, on the left side of the steering wheel, just above your left leg. The wiring adapter you will need to connect the Draw-Tite Brake…
view full answer...I attached a chart that has the automotive cross reference for the Kodiak disc brake pads part #K2250CP that you referenced under the yellow heading. Probably the easiest to look up would be 1982 to 1992 Chevy Cavalier.
view full answer...Hi Greg; we do carry a hitch and wiring for your 2025 Sienna. The best hitch is the etrailer #e56RR. This has a 2" receiver, bolt-on installation, and a matte black powder coat finish. It also comes with a limited lifetime warranty. For wiring…
view full answer...Filters
- 10 results
Filter Results
Hull
$274.95 - $629.13
Pontoon
$38.62 - $38.62
Yacht
$360.44 - $814.44