2022 Keystone Blind Spot Detection

Hey David, The LaSalle Bristol RV Roof Replacement Kit w/ XTRM Membrane #344270KIT30 does need to be installed on a clean surface per the installation instructions: - Make sure the deck is clear of all debris. NOTE: XTRM PLY membrane must be…

If you are looking for a suspension lift for your Forest River Wildwood X-Lite 273QBXL due to its low ride height the best option is absolutely the Dexter Trailer Springs Over-Under Conversion Kit #K71-384-00. The reason is this will give you the…

Hey Bryan, I would go with the Kenda Karrier KR53 part #KE72EV to use as a spare on your 2012 Jayco Jay Flight travel trailer. Its the correct size wheel and tire that you need, it's the Load Range D you need, and also is the best priced option…

Hello Rocky, thanks for reaching out. If your new leaf springs do not have as much of an arch as the old springs they are definitely not going to help your situation if your tires are already rubbing on the fenders. What we would usually do here is…

Hi Stephen, If your weight distribution hitch is overrated for the tongue weight of the trailer then it will over-distribute the weight and start lifting both the trailer tongue and rear of the tow vehicle up. You'll notice handling issues while…

Hello Bob, thanks for reaching out. Unfortunately there is not a camera available that is compatible with the Voyager WVOS54 monitor. This is an older first gen camera system and they have been discontinued so we do not have a compatible camera. The…

To convert the WFCO WF-8955PEC to be lithium compatible you'd need the part #PD4655V and you'd be set. This fits in the panel without any modifications.

While I am unable to find a removable plug which matches your dimensions you may be able to replace the entire assembly with the Stainless Steel Cap and Plug #LHCS108-SI60C. This cap fits a wheel with a pilot hole of 4-1/4" which is the common…

Joe, I was able to track down a diagram and find out that the Telesteps Telescopic A-Frame Ladder #TE37FR is 15.4" wide all the way up and down until it reaches the base where it extends to 30.1".

You will have to go with a sliding hitch to allow the trailer to make tight turns. For a trailer 8 feet wide the only bed length that's going to allow 90 degree turns without a slider is a stationary hitch. That being said you have two options.…

According to Lippert, the correct bearing kit is the #BK3-200. This includes the #14125A outer and #25580 inner bearing, along with the 10-36 grease seal.

Yes, the Replacement 7" Monitor for Furrion Vision S Wireless RV Camera System #FR47FR can be used as a replacement option for the 4.3" Monitor for Furrion Vision S Wireless RV Camera System #FR77FR and would be compatible with your current…