# 1
Draw-Tite Ball Mount for 2" Hitches - 3/4" Rise, 2" Drop - 8-1/2" Long - 7.5K
I recently purchased a class III Curt hitch, mount, ball, wiring harness and hitch pin for my 2011 Toyota Rav 4. The installation was as described, straight forward and easy. The instructions were easy read and matched the vehicle I have. Everything fit together exactly with no modification needed. Shipping was directly to my door. The unit was undamaged and everything was shipped all in the same box. I have used my hitch several times, and although I an new to towing, I look forward to years of use. I did have to make a quiet clamp for the banging mount with an empty trainer, but from what I understand, this is common to all hitched.
It will do the job, for sure.
# 2
etrailer Ball Mount Kit for 2" Hitches - 7,500 lbs
this is a great set of hitches. have used the 1 7/8 hitch for the most part but enjoy having the 2" just in case. I also like the varying distances that they can be raised or elevated for a variety of needs. I am very satisfied. Thank you James J.
Pretty happy with this kit. I like the fact that I can store and carry the ball and mounts in the bag and take them with me for use on another vehicle. I did replace the pin and cotter pin with a locking style pin because this did not appear to be very secure.
# 3
Curt Ball Mount for 2" Hitches - 1" Rise, 2-1/4" Drop - 7-5/8" Long - 7,500 lbs
Needed the 6” drop to flip and make a 6” rise for my 2021 rav4 prime
Purchased the hitch and wiring kit for my 2012 Rav4. I was going to have a garage do the installation, but then decided to do it myself. The written directions and the available videos made the installation of the wiring and the hitch a relative breeze - and I'm not particularly handy. My hitch lined up with the bolt holes perfectly and the wiring was without drama. All in all a good purchase and I was very happy dealing with etrailer. Hooked up the trailer today and all works as it should.
# 4
Curt Class II Drawbar - 3/4" Rise, 1-1/4" Drop - 6-3/4" Long - 3,500 lbs
It's a receiver hitch! It's well built, the welds are clean and it fits the trailer hitch. Not much else to say!
# 5
Draw-Tite Drawbar for 1-1/4" Hitches - 5/8" Rise, 1-1/4" Drop - 7" Long - 3.5K
Finished nicely and fit perfectly, except had to take a file to the inside of the receiver as the punched holes deformed the tube slightly. Now...smooth!
good product, good quality. on time delivery
# 6
Draw-Tite Drawbar for 1-1/4" Hitch - 2-1/8" Rise, 2-3/4" Drop - 6-5/8" Long - 2K
Hitch installation went well after viewing the installation video. The wiring harness video was not completely accurate but provided more than enough visual information to perform the wiring install in a reasonable time. Overall, very happy with product at this time due to easy install due to seller videos. Haven;'t used it yet other than to take a test drive, so, sorry no videos, Etrailer provides a good product with excellent product support. Shipping was very fast and of course the price was right. I would definitely use them again.
Can't wait to get them installed and see how they fit.
# 7
Curt Towing Starter Kit for 2" Hitches - 2" Ball - 3/4" Rise, 2" Drop - 7.5K
The equipment was top rated. I do like the lock option. The only negative I would mention is, for my vehicle, the mechanic needed to weld one side of the attaching tow bar because the dimensions didn't quite match a Toyota RAV4.
# 8
Draw-Tite Ball Mount for 2" Hitches - 2-3/4" Rise, 4" Drop - 9" Long - 7.5K
The etrailer.com site was easy to navigate and I found the right draw bar for my new Rav4. The order was processed very quickly and delivery was within just a few days of the order. Prices are fair and customer service was great. Thanks for a great online experience!
Received it exactly when they said it would arrive. Works great. Exactly as described.
# 9
Curt Class III Ball Mount with 1-7/8" Ball - 2" Drop - 3,500 lbs
Needed the 6” drop to flip and make a 6” rise for my 2021 rav4 prime
Outstanding hitch, wiring harness & attachments. Online help (when given the trailer manufacturer and year) chose correct size and offset for ball to perfectly align trailer and car. You can see the lawn tractor sitting absolutely level on the trailer with the snow flying. It shows why I was in such a rush to acquire the hitch. From online chat with sales agent to her selection of right fit for the particular trailer and car to the ease of installation and the perfect ride behind my RAV4...RATING: A+! Couldn't be happier. Expedited 2 day shipping arrived exactly as promised. So impressed!!! Thank you etrailer for outstanding service. Very happy customer!
# 10
Hidden Hitch Ball Mount - 3/4" Rise, 2" Drop - 15-3/4" Long - 6,000 lbs
I have a 2004 RAV 4 and I was trying to get my ball away from the spare tire carrier. I think I probably would have been fine with the next size (shorter) ball mount and still got the job done. The good news is that with the 2 inch drop, I can open the rear door and it just rubs the seal at the bottom of the door a little bit, but I can still easily open the door. I did not want to drop the ball any lower, So this works out well for my rig.
This worked great. Enabled us to put the tailgate down on our truck without it hitting the trailer tongue jack. Changes the angle a bit for backing up, but we got used to it.
# 11
Curt Ball Mount for 2" Hitches - 3/4" Rise, 2" Drop - 10-1/4" Long - 7,500 lbs
Longer stinger let me drop the tailgate on my Tacoma with trailer attached. Replaced a similar but shorter Curt hitch and both are very substantial and well made for the weight of my trailer.
With good information from the website it was easy to order a Curt 2" Trailer Hitch, the Upgraded Circuit Protected Tail Light Converter Hardwire Kit w/ 4-Pole Connector and Circuit Tester - 119178KIT, Curt Ball Mount for 2" Hitches (3/4" Rise, 2" Drop - 10-1/4" Long - 7,500 lbs - D-4), Curt Pin and Clip Hitch Receiver - C21500, Rubber Tube Cover for 2" Trailer Hitch Receivers - I-728,Review, and 2" hitch ball 40038. Parts were delivered earlier than the initial estimate. Self installation (on a sloped drive way) took just under 2 hour. The fit of parts was very good, instructions and on-line video's were very helpful. My Kia did not have the wire plug in option, but the splice connections in the wire kit were easy to install. Most of the parts are hidden from view when the ball mount is not used.
# 12
Curt Class II Drawbar - 2-5/8" Rise, 3-1/4" Drop - 7-1/4" Long - 3,500 lbs
The 5 inch rise on this hitch ball mount was perfect for my 07 Toyota Rav4. The rear door opens to the side on this year Rav4 and it has plenty of clearance. I tow a 16 ft aluminium boat and this 5 inch rise ball mount works perfectly on the Rav.
# 13
Curt Class II Drawbar - 5" Rise - 11-5/8" Long - 3,500 lbs
The Curt Class II Drawbar with a 5" rise very nicely solved my problem when hooking up my two trailers to my Rave 4. The trailer jack was as low as it could go when it rested on the ball in my of setup. Now I have plenty of jack room to hook up and unhook. Thanks for your excellent product and service. Ralph E.
# 14
MaxxTow Adjustable-Height Ball Mount - 2" Hitch - 7-1/2" Drop, 6-1/4" Rise - 5,000 lb
This is exactly what I needed for my front end mounted receiver.
As advertised and quick delivery, I am an Etrailer fan!
# 15
Curt Ball Mount for 2" Hitches - 4" Rise, 6" Drop - 9-1/4" Long - 7,500 lbs
Needed the 6” drop to flip and make a 6” rise for my 2021 rav4 prime
Easy install, everything included, and great instructional video. Worked out great for my RAV4.
# 16
Curt Class II Drawbar - 5" Rise - 9-5/8" Long - 3,500 lbs
The 5 inch rise on this hitch ball mount was perfect for my 07 Toyota Rav4. The rear door opens to the side on this year Rav4 and it has plenty of clearance. I tow a 16 ft aluminium boat and this 5 inch rise ball mount works perfectly on the Rav.
# 17
Ball Mount 3/4" Rise or 2" Drop - 12-5/8" Long
Needed the 6” drop to flip and make a 6” rise for my 2021 rav4 prime
Superb quality product that solved my RAV4 rear hatch to trailer winch post problem with it's extra long length!! Super fast shipping!! Can't get any better than etrailer!! Thanks!!
# 18
etrailer Ball Mount Kit - 3/4" Rise or 2" Drop - 7,500 lbs
Great deal for what you get.
this is a great set of hitches. have used the 1 7/8 hitch for the most part but enjoy having the 2" just in case. I also like the varying distances that they can be raised or elevated for a variety of needs. I am very satisfied. Thank you James J.
# 19
Curt Class III Drawbar - 2" Rise - 4" Drop - 13" Long - 7,500 lbs
The 5 inch rise on this hitch ball mount was perfect for my 07 Toyota Rav4. The rear door opens to the side on this year Rav4 and it has plenty of clearance. I tow a 16 ft aluminium boat and this 5 inch rise ball mount works perfectly on the Rav.
# 20
Curt Class III Ball Mount with 2" Ball - 4" Drop - 2" Rise - 7,500 lbs
Needed the 6” drop to flip and make a 6” rise for my 2021 rav4 prime
What our customers are saying:
"I received this order yesterday. Thanks for the outstanding service. I appreciate it! Thanks, Alex"