2022 Chevrolet Colorado Truck Bed Rail Caps

Hi Eric; it looks like there are a few different versions of the Gator hard folding covers so I'm not entirely sure which one you have. If it mounts inside the bed rails it is compatible with the TS rails. If it mounts on top then it is not…

Hey George, thanks for reaching out! I'm attaching a photo from the instructions of the Westin E-Series Round Nerf Bars #23-1950 mounting hardware for you to check out. I don't know exactly where the DEF tank is on your 2013 Silverado or how…

Hey Adam, yes the B and W hitch part #BW47BR that you referenced is a confirmed fit for your 2025 Toyota RAV4 plug in hybrid. What are you planning on using the hitch for?

Thanks for the picture Gladys! To add a set of towing mirrors to your 2019 Ram 1500 Classic Warlock, I recommend the CIPA item #CM11400. These mirrors are custom fit and will slide right over your factory ones to extend your line of sight while…

Hey Rob, the Torklift camper tie downs part #TL87DR that you referenced are the correct tie downs for your 2024 Ford F-250 long bed with a factory hitch and will work with any of the steps we sell. The only ones it doesn't work with is the…

Hello Dave, Yes, the Thule TracRac SR Sliding Truck Bed Ladder Rack - 1,250 lbs #TH43003XT-000 fits both the 2020 Ford F-350 and the F-450. This would be a great fit for your 2020 F-450 Crew Cab 4WD Dually. I attached an install video to help with…

The correct hardware kit you need is going to be the Replacement Hardware Kit for TracRac SR Ladder Rack Base Rails part #752-186-3001 which works on both long and short bed models though you will have left over parts if you do have a short bed. The…

There is not a custom fit bed rail for your 1999 Ram 1500 6-1/2 foot bed. The closest we have to what you are looking for is the Putco Truck Bed Rail Protective Skins - Stainless Steel #P59690 which is a custom fit for 2008 to 2013 Chevy Silverado…

I may have a solution for you, but there isn't an offset ball that fits the Ford factory gooseneck hitches. With that said, depending on the design of your gooseneck coupler you may be able to use the B&W Extend-A-Goose #BWTEXA4200. This…

In regards to the B&W Companion OEM 5th-Wheel Hitch part #BWRVK3300 (150 lbs), the pivot arms can be adjusted so that the kingpin is positioned 3" in front of the axle or 1" behind the axle. In regards to the Andersen Ultimate…

Hi Duane, Air Springs are better for leveling loads and will typically give you a rougher unloaded ride quality so these might not be the best option for your setup depending on what your intended use is. Air springs are the best option when it comes…

Hello David, thanks for reaching out. I hate to be the bearer of bad news, but your only option here will be a new camera system. The WVOM541AP is the old generation of Voyager monitor which is now discontinued. Voyager moved to the WiSight 2.0…