2008 GMC Canyon Truck Bed Bike Rack

The 1-Bike Add-On for Thule Bed Rider Pro Truck Bed Bike Rack #TH98YC is meant to fit onto the square bars of the Thule Bed Rider Pro #TH38YC which uses a 30x20mm (1-3/16" x 25/32") square bar. With your bars…

I do have a solution for you but there have actually never been any custom towing mirrors made for a Nissan Frontier and so I would be surprised if any ever come out for your 2019 Nissan Frontier. Since this is the case I recommend using the…

I spoke with my contact at Kuat and he informed that the Kuat Dirt Bag part #DRT15 is designed to fit axle sizes that are 15 mm x100 mm. To see more dimensions for this product check out the picture I attached.

Yes, it will so long as you have one of the following bike racks Y02473, Y02473-02475, Y02474, and Y02474-02475! The Replacement SpeedKnob for Yakima Dr. Tray Bike Racks item #8880717 fits a mixture of 2" and…

For your 2024 Ford F-250 I recommend checking out the Half Tailgate Pad for Trucks #BDW79QB. This is a tailgate pad that just drapes over your tailgate and gives you the ability to carry up to 2 bikes securely and easily. The pads are…

The hardware you'll need to mount the Saris Fork Mount Bike Carrier #SATR1BLK to the Saris Traps Fork-Block 3 Bike Rack #SATRK14-BLK3 is as follows: Flat Socket Head Cap Screw 1/4-20x1 Flat Washer 1/4 Nylock Nut 1/4-20 If you jump…

Personally I wouldn't go with Timbren's for your needs. They're essentially rubber bump stops that prevent your suspension from flexing when weights placed on the rear of your Canyon. The major issue…

Hey Ryan, so there isn't a special type of pipe that the LaSalle Bristol RV Shower Drain w/ Grid Strainer #34433JN1202 is designed to only work with. The PVC or polyurethane you mentioned from Home Depot would work great.

I'm assuming your 2024 F-250 has the 6-3/4' bed. If that is correct, the right tie-downs are in fact the #TLF3008 and #TL77CR. TorkLift has accounted for the bed access steps on the 2024 model and confirmed these will…

The Inno Velo Gripper Bike Rack for Truck Beds, part #INRT202 is designed for trucks just like your 2012 Frontier. I have attached a photo of the #INRT202 for you. The small square plate( pointed out with an arrow in the photo) attached to the eye…

The Saris Traps fork-block 3 bike carrier #SATRK34-BLK3 you referenced can be mounted on a 2x6 board instead of the truck bed. I called our representative at Saris to confirm as well. I added a informative article about truck bed bike rack systems…

Yes the Saris Traps Fork-Block 3 Bike Rack part #SATRK34-BLK3 does included the three fork mounts. It is 47" wide so as long as your Gladiator has that width in the bed it will work out great.