What our customers are saying:
In these days of customer "no service" I am usually disapointed when doing business with people I don't know. It was refreshing doing business with you. I'm impressed!
Randy
Watkinsville, GA
Videos
for Trailer Bearings Races Seals Caps
Help Articles
Expert Answers
Even though I cannot comment specifically on the grease you used because I am not familiar with it, I can tell you the best grease for trailer bearings is a a grease with a rating of GC-LB, which just means it is made to withstand very high…
In order to determine the torque rating for the lug nuts on your trailer you will need to know check out the chart I attached that shows all of the torque specs for all the trailer lugs available based on stud size, wheel material and wheel size.
Trailer wheel bearings are specific to the spindle that is installed on the axle that is on your trailer. You will need to safely support the trailer, remove the wheel and tire, remove the grease cap, remove the cotter pin and washer that secures the…
Hey Barry, sure do! The seal that comes with the #DX87UR bearing kit is a 1.719" ID and 2.565" OD. We offer this seal individually as part #58846.
From the numbers you provided it sounds like you need replacement grease seals. In my research, the grease seals I found with the GS-1719DL number have a 1.72 inside diameter and 2.565 outside diameter. The replacement double lip grease seals you…
You are going to want either our Bearing Kit #BK2-100 or the Timken Kit #TMK52VR. Both of these kits will give you the inner/outer bearings and races along with a grease seal and cotter pin/D-washer for one hub. You always want to replace the race…
Hey Robert, yes the Kodiak disc brake calipers part #KDBC225DAC that you referenced will replace the Tie Down calipers you have now 46304, they can be used as a left or right hand caliper and does come with ceramic brake pads. If you ever needed…
After you've packed the bearings and assembled everything, carefully slide the hub assembly onto the spindle and install the outer bearing. Install the spindle and tang washer and run the spindle nut down finger tight, then rotate the hub back…
To replace your NOK AD2527E seal you can use #168233. It has an inner diameter of 1.688 inches and an outer diameter of 2.332 inches. Based on what I could find on the NOK AD2527E the inner diameter is the same and the outer diameter is 2.328 inches.…
The Tru Ryde grease seals you mentioned, part #RG06-70 are indeed a replacement for the 10-036-00 Dexter seals. They would work great for your application.
You can verify that the 10-19 grease seal included in Bearing Kit #BK2-100 is the correct one for your spindles by taking two measurements. First you want to measure the rear hub bore where the seal is inserted. The seal's outer diameter needs to…
2019 Keystone Accessories
Towing
2019 Keystone Trailer Hitch
2019 Keystone Blind Spot Detection
Performance Accessories
2019 Keystone Tire Chains
Vehicle Trim
2019 Keystone Wheel Cover
RV and Fifth Wheel
2019 Keystone RV Vents
2019 Keystone RV Mattress
2019 Keystone RV Tires and Wheels
2019 Keystone RV Covers
2019 Keystone RV Fireplace
2019 Keystone RV Weight Distribution
2019 Keystone RV Hubs and Drums
2019 Keystone RV Brakes
2019 Keystone RV Roof Membrane
2019 Keystone RV Bearing
2019 Keystone Trailer Jack
2019 Keystone Spare Tire Cover
2019 Keystone RV Camera
2019 Keystone RV Doors
2019 Keystone RV Propane
2019 Keystone RV Interior Lighting
2019 Keystone RV Exterior Lighting
2019 Keystone RV Power Inlets
2019 Keystone RV Power Cord
2019 Keystone RV Plug Adapters
2019 Keystone RV Jack Pads
2019 Keystone RV Bike Racks
2019 Keystone RV Antenna and Radio
2019 Keystone RV Air Conditioner
