Brake controllers are an essential part of a towing system with electric trailer brakes, and they offer a much-needed emergency braking feature. We offer high quality controllers from manufacturers such as Draw-Tite, Tekonsha, REDARC, Hidden Hitch and Hopkins. Featuring both time-delay and proportional models, we have the right controller for any application. Brake controller wiring adapters are available for many vehicles, allowing for simple plug-and-play installation. Hardwire kits are also available to make any installation hassle-free.
Find your custom fit brake controller wiring adapter for a plug-in application by selecting the year of your vehicle to the left. We offer custom fit plug in adapters for many of the most popular vehicles, including Ford, Chevrolet, Dodge, GMC, Nissan, and Toyota.
Videos
for Trailer Brake Controller
Help Articles
Expert Answers
A 4-Way trailer connector has the basic lighting functions only; running lights, left turn signal and brake lights, right turn signal and brake lights, and ground. A 7-Way has these functions and a 12 volt circuit, a circuit for electric trailer…
If your vehicle has a factory brake controller plug, you can simply use the Tekonsha Plug-In Wiring Adapter for Electric Brake Controllers – Ford, Item #3034-P, which will connect to the vehicle plug and the brake controller. On the new E-450…
While we may have an option for you, we do not have the exact specs on your Allis grease seal part number 5013 29772. However, with the…
The correct replacement master cylinder kit we have for your Demco setup is the part #DM5918 which comes with the lock out replacement.
The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…
The Tekonsha OEM Vehicle Wiring Harness #22121 that you referenced includes all the wiring and parts necessary to install a fully functional 7-Way connector and trailer brake controller. The included brake controller harness is compatible with and…
If you just need a 4-pin to 7-pin trailer wiring adapter, then you can use part #C57672. This will plug into the 4-pin trailer connector on your…
Hey Jeremy, Typically with boat trailers the manufacturer will install hydraulic surge brakes because you…
To see all of the correct wheel and tire combos…
If your current springs have 5 leaves then going to a 7 leaf spring will increase the height of the trailer a little and make the trailer more susceptible to sway. Regarding capacity if you go with springs rated higher than what is required it will…
I did some checking and the hub/drum we offer that will work for you is the part #8-430-5UC3. This uses the same bearings as the 8-415 and will be an exact fit aside from the fact this is a non-ABS setup and the 8-415 came in an ABS setup and…
The number you provided,…
Brake Controller Manufacturers