1996 Kia Sportage Air Filter

We have a similar etrailer hitch that fits your 2021 Ram 1500 Classic with the part #e98852, but the #e28ZR fits the non-Classic models.

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

A 4-Way trailer connector has the basic lighting functions only; running lights, left turn signal and brake lights, right turn signal and brake lights, and ground. A 7-Way has these functions and a 12 volt circuit, a circuit for electric trailer…

Yes, the Lockrack Adjustable Watersport Carrier #LR24VR will absolutely work with the aero bars on your 2023 Toyota Corolla. The clamps on the Lockrack carrier are designed to be universal, and will fit virtually and crossbar shape, including your…

You can tow your gooseneck trailer with your truck that has 5th wheel hitch rails already, but you can't install a separate in-bed gooseneck hitch; reason why is the brackets for a gooseneck and 5th…

Yes, the etrailer Trailer Hitch Receiver #e83ZR is an excellent choice for your 2024 Subaru Forester! My favorite part about this hitch is the matte black finish because it not only does a great job at matching any black finish on your vehicle, but…

For your 2020 Chrysler Voyager that has the seventh VIN digit as D the correct trailer wiring install harness is the Curt #C56399.

Aside from a slight change in the appearance of the crossbar (the WingBar Evo has some boxed edges as opposed to the completely smooth front of the AeroBlade) the biggest differences are the rubber strip on top of the crossbar and the weight…

You will have to go with a sliding hitch to allow the trailer to make tight turns. For a trailer 8 feet wide the only bed length that's going to allow 90 degree turns without a slider is a stationary…

I have an axle that is pretty close to what you're wanting, but is not going to work as the spring center measurement is a bit off and it needs to be just right to work. I do have a solution though.…

Technically, your A-Frame Bulldog Powered Jack, Item #BD500199, can be powered by the 12 volt circuit on a 7-Way trailer side connector which is in the 1 o'clock position where the wires connect if…

Yes, you can use the Bulldog Powered Drive Trailer Jack #BD500199 in place of your existing jack because the mounting hole pattern in the bracket will be the same between the 2 jacks. Provided that your existing jack also has a round outer tube…