Features to know about

More Support for Demanding Rear Loads

Your truck can feel composed empty, then change quickly once substantial pin weight, a slide-in camper, or a heavy work payload settles onto the rear suspension. The two adjustable rear air springs provide up to 7,500 lbs of load-leveling support to help bring a sagging rear back toward normal ride height while reducing sway and bottoming under load. Instead of treating that capacity as a target, you can tune the air pressure to the weight your truck is actually carrying.

Heavy-Duty Support That Backs Off When You Do

A truck built for serious towing or hauling may still spend plenty of miles without that weight on the rear suspension. Internal jounce bumpers let you increase air pressure when a substantial load calls for more support, then reduce the air springs to 0 psi when the extra weight comes off. Those internal jounces protect the air springs against bottoming when suspension travel is used up, so you don't have to maintain air pressure simply to protect the bags during unloaded driving. The result is adjustable support that can work around both sides of your truck's job instead of treating every mile like a loaded one.

Corrosion Resistance Where Exposure Hits Hardest

Suspension hardware lives where road spray, dirt, and weather reach it, so material choices matter underneath your truck. This kit uses braided stainless steel air lines along with stainless steel fittings, Schrader valves, roll plates, and mounting hardware to add corrosion resistance throughout key parts of the system. That extra durability is focused where it matters, helping the hardware you rely on for load support and pressure adjustment stand up to the environment beneath a working truck.

Custom Installation

You'll start by measuring your truck's stock ride height and checking tire-to-frame clearance before removing the factory jounce bumpers, with rear-wheel removal optional if you want more working room. The air spring assemblies mount between the frame and axle using the existing jounce-bumper mounting locations up top and axle straps below, with careful attention to brake-line clearance as the upper brackets are positioned. Once the springs are aligned and secured, you'll relocate the emergency-brake line with the included hardware, install the passenger-side exhaust heat shield, then route the braided stainless steel air lines with enough clearance and slack for suspension movement before mounting the Schrader valves where they're easy to reach. Adding air bags is a job experienced DIYers can handle, but if you would rather leave it to a professional, we can help you find an installer near you.

Upgrade Your Air Control

The included Schrader valves give you everything you need to adjust the air springs manually, but pulling out an external compressor can get old when your truck regularly switches between demanding loads and unloaded driving. You can add a Pacbrake Bravo Wireless Air Control Kit with XD Compressor (sold separately) to adjust pressure from your phone, check live pressure, and save presets for loads you come back to regularly. Also, you'll be able to choose between filling both air springs together or controlling them independently when the load isn't even side to side. It's an optional upgrade, but one that makes the adjustable part of an air-spring system much easier to use regularly. And it's not the only solution available. There are a variety of compressor options from Pacbrake that might be the perfect fit for your setup.