9" Wide x 32" long x 15" tall. This sturdy, rounded fender has a durable backing plate that helps protect your trailer from debris. Ribbed, 16-gauge steel is built to last. Bolt or weld onto your trailer.
Features:
Specs:
Note: Do not use the backing plate to mount the fender to your trailer.
Videos are provided as a guide only. Refer to manufacturer installation instructions and specs for complete information.
Ellen: Hey everyone, I'm Ellen here at etrailer.com and we're going to be taking a quick look at the single axle trailer fender with backing plate. So this is a really great way to protect any drivers on the road from any kind of debris getting kicked up or slung up underneath your tires and causing any issues with them, but also it's going to protect any gear that you're hauling. With the backing plate included in this, it makes it really nice for open trailers as well, to make sure that no gunk or rocks or debris or anything is going to come up and damage whatever you're hauling, whether that be any kind of equipment, vehicles or anything else. So it's going to be a really nice addition to your trailer to make sure that everything is protected and that no rain or mud or water is getting slung up and slung around, and also to keep everything else in place on your trailer as well.This is made out of a 16 gauge, cold rolled steel. So it's going to be nice and durable. You can weld this in place or you can bolt it on, it doesn't have any pre drilled holes for bolting, but since it does have just a raw finish, you can weld it in place.
That being said though, once you get this in place, you'll probably want to prime and paint it to match with the rest of your trailer to make sure that it's protected from any kind of rust or corrosion. You can see that backing plate, it is welded in place. So it's going to stay attached to the fender itself, got kind of a ribbed design to the top of the fender. So it's going to have a nice structural stability. As far as the overall length, it's about 32 inches long from outer edge to outer edge, and then 15 inches tall from the base to the top or the apex.
And then it's about nine inches wide from front to back.It does have a one inch curved radius at the lip here. So it's a one inch radius for that. So it gives it a nice finished look. This does just come as a single fender, so you'll need one for either side. It weighs about nine pounds, it's made in the USA, and its covered by a one-year limited warranty.
And that's pretty much all there is to it for our look at the single axle trailer fender. I hope this has been helpful in deciding if this is the right one for you. We do have a lot of other options available though here at etrailer.com for all kinds of stuff for your trailer, so check them out. Thanks for watching.
Average Customer Rating: 4.7 out of 5 stars (297 Customer Reviews)
9" Wide x 32" long x 15" tall. This sturdy, rounded fender has a durable backing plate that helps protect your trailer from debris. Ribbed, 16-gauge steel is built to last. Bolt or weld onto your trailer.
Do you have a question about this Trailer Fender?
Info for this part was:
At etrailer.com we provide the best information available about the products we sell. We take the quality of our information seriously so that you can get the right part the first time. Let us know if anything is missing or if you have any questions.
Thank you! Your comment has been submitted successfully. You should be able to view your question/comment here within a few days.
Error submitting comment. Please try again momentarily.