Single Axle Trailer Fender with Backing for 15 Inch Wheel

Question

Question:

Which fender backing fits this fender?

asked by: Dale

0

Expert Reply:

The backing is not sold individually for the Single Axle Trailer Fender # HP66FR.

For a similar fender that does include the backing, you can use part # HP29FR. This fender is designed for 14 inch -15 inch wheels and has the same rib design as the fender you referenced.

expert reply by: Victoria B

0

Answer 1

The closest thing to what you are looking for is the etrailer Fender #HP29FR. This measures 10-3/4" Wide x 32" Long x 15-1/4" Tall, is made of 16-gauge steel, and is compatible with 14" - 15" wheels. The only difference…

view full answer...

Answer 2

To install the Single Axle Trailer Fender w/ Backing Plate #HP29FR you need to use the Mounting Brackets #CE26098G-2. The backing plate isn't strong enough but these mounting brackets install to the fender itself so the weight isn't an…

view full answer...

Answer 3

In order to determine the torque rating for the lug nuts on your trailer you will need to know check out the chart I attached that shows all of the torque specs for all the trailer lugs available based on stud size, wheel material and wheel size.

view full answer...

Answer 4

According to Blue Ox, it'll take an experienced installer about 4 to 5 hours to complete the installation of their #BX1128 Base Plate Kit on a 2016 Jeep Grand Cherokee. The install isn't what I'd call super-difficult, but the installation…

view full answer...

Answer 5

It sounds like you are speaking of the wires for the brake magnets. If this is correct, you will need to connect one of the wires to the brake controller output wire on your trailer connector and the other wire will need to be grounded to a clean…

view full answer...

Answer 6

The #84 spindle is just a common way to identify the spindle dimensions typically used for 3,500 lb axles. So instead of listing out the parts, people can just say they have #84 spindles and it's easier to know what fits it. The CE Smith Trailer…

view full answer...

Answer 7

Even though I cannot comment specifically on the grease you used because I am not familiar with it, I can tell you the best grease for trailer bearings is a a grease with a rating of GC-LB, which just means it is made to withstand very high…

view full answer...

Answer 8

The Demco Hydraulic Trailer Brake Actuator part #DM72VR should be a direct replacement for the Atwood 61101 Brake Actuator that you have now. This newest updated it rated at 7K instead of 6K. This is a bolt on option that mounts on 3" centers.…

view full answer...

Answer 9

To determine the size of the brake assemblies you need you have to measure the depth and width of the hub drum on the axle like what you see in the picture I attached. The most common size is 2-1/4 inch wide like the #T4071600-500 that you…

view full answer...

Answer 10

Hi Calvin! All of the pre-greased hubs/drums, like the Terran Industries Trailer Hub and Drum Assembly - 3.5K Axles - 10" Diameter - 5 on 4-1/2 #TX68VJ, come with bearings made overseas and are all basically the same quality. At least that I…

view full answer...

Answer 11

That's a very good question, we tend to be extra cautious and say to use 10 gauge wire because that would be more than enough. When you get into longer trailers that will end up using a lot of wire the heavier gauge wire becomes more necessary.…

view full answer...

Single Axle Trailer Fender with Backing for 15 Inch Wheel

Products Featured in This Question

Product Page this Question was Asked From

Continue Researching