CE Smith Boat Trailer Parts
- CE10191GA-4
- Bunks
- Swivel Bracket
- U-Bolt Bunk Bracket
- 3-1/2 Inch Long
- Galvanized Steel
- 1-1/2 Inch Wide
- 4 Inch Wide
- 2 Inch Tall
- 9-3/4 Inch Tall
- CE Smith
Rust-resistant assemblies let you install 2 bunk boards on your boat trailer. Each assembly attaches to the trailer frame with 2 U-bolts (sold separately) for a sturdy connection. Swivel brackets enable bunks to tilt when loading a boat.
Features:
- Bolster-and-swivel-bracket assemblies allow you to install 2 bunk boards on your boat trailer
- Extra-sturdy connection to trailer frame ensures support for the bunk boards
- Each bolster bracket attaches with 2 U-bolts (sold separately), as opposed to a standard bracket that attaches with 1 U-bolt
- Mounting slots permit as much as 3" of height adjustment during installation
- Bolster brackets install vertically on your boat trailer's frame
- Heavy-duty swivel brackets let you tilt the bunk boards
- Helps you to fit the boat hull snugly onto your trailer during the loading process
- Hardware is included for attaching the swivel brackets to the bolster brackets
- 3 Bolt holes allow for a strong, sturdy connection to the bunk board
- 7-Gauge, galvanized steel resists rust and corrosion
- Suitable for saltwater exposure
- Made in the USA
Specs:
- Quantity: 4 bracket assemblies
- Overall height: 10-1/4"
- Dimensions of bolster bracket: 9-3/4" tall x 4" wide
- Mounting slot dimensions: 3" long x 1/2" wide
- Horizontal spacing between slots: 1-1/4"
- Vertical spacing between slots: 1/2"
- Dimensions of swivel bracket: 3-1/2" long x 1-1/2" wide x 2" tall
- Flange mounting hole diameters: 3/8"
- Flange mounting hole spacing: 2-1/2" apart on center
- 1-1/4" Between each of the 3 holes
![Dimensions of installation brackets]()
![CE Smith double U-bolt bolster brackets installed on a boat trailer]()
Bolster-and-swivel-bracket assemblies are typically mounted upright on a boat trailer's crossmembers. They allow a mounted bunk board, which runs from the front of the trailer to the back, to tilt to accommodate and support boat hulls of different sizes. On kayak trailers, these brackets are mounted to the trailer's frame and support bunk boards that run across the trailer.
Galvanized Steel
Galvanized steel parts are hot-dipped in zinc after being stamped. This creates a coating that is typically 3 mil to 5 mil thick. This thick, all-around coating allows galvanized steel products to provide years of use without rusting or corroding.
10191GA C. E. Smith 7-Gauge Galvanized Steel Replacement Bolster Bracket - Double U-Bolt - 9-3/4" Tall
10206G C. E. Smith 7-Gauge, Heavy Duty Galvanized Steel Replacement Swivel Bracket for Boat Trailers
11089 C. E. Smith 1/2-Inch x 1.25-Inch Swivel or Bolster Bracket Mounting Bolt
10812 C. E. Smith 1/2-Inch Swivel or Bolster Bracket Mounting Locknut
WARNING: This product contains Lead, a chemical known to the State of California to cause cancer and reproductive harm. For more information, go to www.p65warnings.ca.gov.
Thank you! Your comment has been submitted successfully. You should be able to view your question/comment here within a few days.
Error submitting comment. Please try again momentarily.