To see if this custom-fit item will work for you please tell us what vehicle you'll use it with.
Thank you! Your comment has been submitted successfully. You should be able to view your question/comment here within a few days.
Error submitting comment. Please try again momentarily.
When you need to haul something tall or oversized, you don’t have to take this cover off. The BAKFlip G2 folds in sections so you can open part or all of your bed in seconds. Built-in prop rods hold the cover upright for full access while you drive, and rubber bumpers keep it from touching the cab glass. You can also secure it halfway open using the integrated buckle straps when you want airflow but still need coverage over part of your cargo.
You don’t need a separate lock for this cover—just close your tailgate. Once the tailgate is shut and locked, the G2’s panels automatically latch underneath so no one can lift or pry them open. The aluminum panels are 1/2" thick and rustproof, so they can’t be easily cut or bent. Each latch engages under its own weight as you fold the cover closed, making it quick to secure the bed before heading out.
Rain and wash water won’t ruin what’s in your bed. Matte black rubber seals run around the entire perimeter to keep moisture out, and a built-in gutter system channels any water that does get through into drain hoses behind the cab. The corrosion-resistant black paint finish and UV-stable coating protect the aluminum from fading or chalking, so it keeps looking clean even after long exposure to the sun.
Each panel is made from rustproof aluminum with an insulated core for extra strength. The cover supports up to 300 lbs of evenly distributed weight when closed, so standing or setting gear on top is no problem. The textured, hair-cell black finish resists corrosion and scratches, and the powder-coated rails mount inside the bed for a flush, low-profile look that still allows stake-pocket accessories or racks to be used.
Installing the G2 takes basic tools and no drilling. The frame rails clamp inside your bed rails, and the front hinge rail bolts into place with adjustable slots to fine-tune the fit. Once tightened, the panels align smoothly and operate easily—no constant adjusting or extra hardware needed.
Ratings & Reviews
Overall, a good product. This is the third BakFlip I've owned on different trucks. Quality wasn't as good as older units. The wires to release the latches are too long and get trapped inside the cover so you can't reach them. I added pieces of tape to fix this problem. Also, the nylon straps to hold it open are a nice addition but the plastic buckles broke almost immediately. Older units with metal rings for you to attach bungee cords was a better design.
As always, etrailer service & delivery are outstanding!
We purchased the BAK Industries BAKFlip G2 Tonneau Cover for our 2019 Ram 2500. We use this cover for security/keeping the weather off of our camping accessories for our RV. The cover works great and is fairly waterproof. The only issues we have had is the 1st latching cable, most of the time we need to pull the cable release from both sides to release the locking lugs to open. Over-all a good purchase, and would recommend it for anyone looking for a hard cover.
Great Tonneau Cover for my Ford Maverick, no issues in a year so I don't suppose there will be any. Fit is perfect and adds class to my little truck. Thanks for a good product.
This is the second BAKFlip G2 Hard Tonneau Cover we have purchased. The first was for our 2005 Chevy. This is for our 2017 GMC. The 2005 fit much better. The 2017 model is not wide enough to actually fit the bed allowing water to easily enter the bed. Also the posts that hold the cover up against the cab were drilled wrong. You have to remove the slide to fit the prop rod. They simply drilled the hole for the nutzert in the wrong spot on the passenger side. Just not the same quality fit or finish as the 2005 version. We would have returned it but sending it back was going to be too much of a hassle due to its size.
This cover is now completely junk due to a hail storm. No fault of BAKflip but the hail storm destroyed the cover is seconds. The aluminum used in this model is just too light to protect from any type of impact.
I was impressed with how your company staff received my order request, how company staff kept me updated on order status and delivery. Installation went very well. The instruction manual was well detailed. I am very satisfied with your cover. The cover fits perfectly. I continue to receive compliments. Thank you from a very satisfied customer.
Love this cover. It was better than I expected. Equally as important I like working with etrailer. Good people that understand and can explain the details of their products. I have used them for a lot of stuff for my boat trailers always with good results.
The tonneau cover is excellent when you get it installed properly. I can only give it a 3 rating because the workmanship of their latches the way they installed them was very shabby. Had to move all the latches back into their frame so they would not hit the side rails, had to re-drill holes that fastened most of the latches to the frame. If they would have taken their time installed the latches properly, then it would have been an excellent tonneau cover all over.
This cover has made leaving items in our truck bed much easier.
I do wish it had a way to secure it when not fully open, I.e. one section open.
I bought this cover so when I tow my fifth wheel camper I can open up and still leave a section closed to cover my air compressor and inverter and when I drop the trailer I can cover my hitch and lock it. It works perfectly for my application. Great quality and sturdy.
Difficult to install
Makes noise at highway speeds
Need pliers to get latches to click into rails to hold on
Flimsy
Poor quality
Camera mounting seems off alittle compared to the original tried adjusting but still the same view
The BAKFlip G2 Hard Tonneau Cover has done an excellent job of protecting our various item in he truck bed while running around town or out camping. It is a good solution to securing items in the truck bed from casual theft.
Good product. I had to re-drill the prop rods for the cover. They were no where near where they should have been. Other than that, the installation went pretty well. Not quite as sturdy as the one I bought 15 years ago from the same company.
It’s well built and stout. Installation was a little tough. I’ve had to adjust lock tabs a few times. It sure works great keeping wheelchair covered.
This cover has been perfect for my application. Previously I had an electric motorized unit that leaked badly when it rained and had no mechanical override in the event the truck was not running. This cover is nearly waterproof and is easily opened and held open for travel if I choose to do so. It looks and works very well.
I have had many brands of hard covers and this one out performs the others.
The installation is critical especially with the RAM box configuration as I have.
All the parts were supplied. Take your time, read and measure twice cut once.
This cover works great and was very simple to instal. Didn’t take much time. The only thing I can recommend is that the instructions are kinda hard to follow at the begging.
Excellent cover! Easy to install. Looks way better on my truck than the old one and being able to fold it all the way up against the back window is very nice.
Ok the cover is great if you use it to secure items in the back but, the down fall is how the system attaches to the Ram trucks. The pressure applied by the bolts for securing the side rails causes the manufacturers bed rails to buckle in the middle which, is minimal if you live in a cold climate but, for the majority, it causes issues. I love the security but I hate what it does to my bed rails.
I ordered a Bakflip tonneau cover and fob lock for my tailgate. Instructions on the cover were perfect. It looks great. Absolutely no institutional videos on my 2011 GMC Canyon for the remote. The wiring connection portion of the install was just past tedious. Once figured out it works like a dream.
Very easy to install. I didn't use the instructions (no, I'm not one of those guys). I used the installation video on the BSK G2 tonneau cover on etrailer.com! It arrived in just a few days and was very well packaged. I can finally store things in the bed of my truck safely. Way to go etrailer and BAK Industries!!
Perfect fit for my 2017 Ford F150 FX4
Super fast delivery & great customer support.
It’s been worth every penny spent
The Bak Flip works exactly as it was designed to do.
It looks good and opens and closes easily.
Water does enter around the edges depending on the unevenness of the surface on which the truck is setting.
Arlan
12/29/2018
Excellent except water still enters through the corners
Do you have a question about this Tonneau Cover?
Info for this part was:
At etrailer we provide the best information available about the products we sell. We take the quality of our information seriously so that you can get the right part the first time. Let us know if anything is missing or if you have any questions.
Tim
1/8/2025
It’s been great for trips, to keep personal belongs covered and hidden. Still worth every penny spent!!!