Replaces the valve for your gray-water tank. 1-1/2" Diameter passage allows wastewater to travel freely when valve is open. 72" Flexible cable lets you install handle where you want it. Valve body, cable, seals, and hardware included.
Features:
To install, remove the broken waste valve and seals from your holding tank. Then place the included seals on the flange fittings and position the new valve body. Tighten the provided hardware to complete installation.
California residents: click here
Videos are provided as a guide only. Refer to manufacturer installation instructions and specs for complete information.
Hello everybody, this is Jeff at etrailer.com. Today, we're gonna take a look at the Valterra Waste Valve Body with the 72 inch long flexible cable for your RV gray water tank. Now, this is a replaceable valve for your RV's gray water tank. You can see, when it's open, you activate it, it'll open up, and that'll give you a 1 1/2 inch diameter passage that allows the waste water to travel freely when the valve is open. And then to close it, you just turn your handle, and that'll close the valve. Now, it will include everything shown here on the table.
It includes the valve body itself, the 72 inch long flexible cable, a mounting bracket, which is included if you wanna install it on your RV's side wall with the mounting hardware, and then it comes with the hardware for the valve body, comes with the two seals, one on each side, comes with the four bolts to install it with the nuts, and it even comes with an Allen wrench to loosen this Allen bolt here to allow you to attach the cable to this portion right here. Now, the cable we mentioned, it's a 72 inch flexible cable, this will let you install your valve handle where you want it, so you don't have to go searching underneath your RV for it. This will allow the handle to be converted from a hard access location to a nice simple push pull placement like the control access panel compartment. The inner wire on this cable is a stainless steel construction. Now, we mentioned, this aluminum mounting bracket here, they do include this, 'cause if you don't have room in your control access compartment, this will allow you to mount the handle to the RV's side wall.
And just to give you an idea, there's an insert there, it shows you how this handle installs into this and then you can mount it to the RV's side wall, comes with the mounting hardware. Last thing I wanna do is just give you some dimensions on this valve body. So if we measure from the bottom to the very top, 10 1/4 inches that way, 3 1/4 inches that way, and the depth at the widest point is down here, 1 1/2 inches deep. But that should do it for the review on the Valterra Waste Valve Body with the 72 inch long flexible cable for your RV gray water tank..
Info for this part was:
At etrailer.com we provide the best information available about the products we sell. We take the quality of our information seriously so that you can get the right part the first time.
Thank you! Your comment has been submitted successfully. You should be able to view your question/comment here within a few days.
Error submitting comment. Please try again momentarily.