Can the Cable on Valterra Flexible Cable Kit # TC172 be Cut Shorter

Question

Question:

with the 72 inch cable on the cable actuated valve...will I be able to cut the length of thecable down to 10 inches or so?

asked by: Chris

1

Helpful Expert Reply:

The cable part of Valterra Flexible Cable Kit # TC172 is not already installed so you could cut it to length if you wanted or needed to in order to get it positioned where you want it.

expert reply by: Michael H

1

Joe

10/2/2025

Do you have the Valtera instruction that shows dims for how much cable needs to stick out after cutting?

Reply

Answer 1

Is this an interior trim piece or a the skis that are on the outside of the slide out like what the part #SR68RR is designed to replace?

view full answer...

Answer 2

So the difference is purely in how the two connect to your sewer pipe, which will also tell you which one you need; one will slide into the pipe (the spigot) while the other will slide onto the pipe (the hub): - Slide Into Pipe: Valterra Waste Valve…

view full answer...

Answer 3

Plumbing parts are interchangeable on RV's just as long as the fittings are the correct size. I couldn't find that exact part number but I believe I have found the Valterra equivalent. If the Bristol valve you are talking about uses the…

view full answer...

Answer 4

No they will all mount differently. For example, LaSalle Bristol Cable-Actuated RV Waste Valve - Black Water Tank - Spigot to Spigot - 96" Cable, part #34466N4BB96GM, needs ABS solvent cement, part #3447530889, to secure the valve to your sewer…

view full answer...

Answer 5

The flanges typically have a gasket between them and the gate valve with a groove in the valve holding them in place. Putting two flanges together with just the gaskets touching each other instead of having an actual groove in the plastic to sit…

view full answer...

Answer 6

LaSalle Bristol doesn't make it so that you can replace much on their cable actuated waste valves besides just the handle so you would be better off just replacing the entire valve and cable system with Valterra's Black #TC372 and Gray…

view full answer...

Answer 7

Hello Pete, thanks for reaching out. The Valterra Waste Valve Body w/ Flexible Cable #VAL54MB comes pre-assembled so it would not be recommended to cut this. A better option would be Valterra Waste Valve Body w/ Flexible Cable #TC372. This has a…

view full answer...

Answer 8

Based on the numbers and RPM you listed on your Dutchman 2007 trailer the correct slide out motor setup you need is the part #LC125802 that is a Tuson High Speed 18:1 9,000 RPM slide out motor.

view full answer...

Answer 9

Hello Danny, The Valterra E-Valve Electric Waste Valve for RV Gray Water Tank - 1-1/2" Hubs #VAL23MB is controlled by a rocker switch, which makes operating your RV’s waste system super convenient. You can mount the switch somewhere easy to…

view full answer...

Answer 10

We sure do! The replacement you're needing is the Lippert RV Slide-Out Motor #LC130057 which Lippert has confirmed for us will replace your older Klauber K01348D500.

view full answer...

Answer 11

Hey Steve, there isn't a way to use a middle X-factor with a Roadmaster comfort ride system unfortunately.

view full answer...

Answer 12

Hello again, Mike. The best way to resolve this is to simply replace your distribution box at the same time as your AC unit. The distribution boxes are not terribly expensive, and that way you would be able to plug the AC right in without any cutting…

view full answer...

Can the Cable on Valterra Flexible Cable Kit # TC172 be Cut Shorter

Product Page this Question was Asked From

Continue Researching