Replace your old and worn out weather stripping around doors and hatches of your RV before water damage creates a costly headache. Adhesive backing is pre-applied for an easy DIY install.
Features:
Videos are provided as a guide only. Refer to manufacturer installation instructions and specs for complete information.
Hello, everybody. This is Jeff at etrailer.com. Today, we're gonna take a look at this 15 foot long stick on hollow, half round rubber seal with the tabs for RVs and enclosed trailers. I want to zoom in here just to show you the type of seal this is. It is a hollow half round rubber seal with the tabs on top here. And it's used to prevent water from leaking into doors or ramp gates on your RV or enclosed trailer.
This can also be used on storage compartments and hatches. It is ideal for the sixties air streams as well as Gullwing doors. And this seal is commonly found on Winnebago and Jacobs storage compartment doors and rear drop gates. This seal helps protect your RV from extreme weather and the pest. And what's nice about this material, and unlike your standard foam seals, this product consists of a nice closed cell core surrounded by a solid skin surface for greater weather and wear resistance.
You can see on the bottom that is a peel and stick installation. Has the pre-applied 3M adhesive backing. You just simply peel off the backing paper and then apply the seal to the surface. Now they do also include these two alcohol prep pads that allow you to clean the surface before installing your seal. And also this seal, let me show you, has a nice feature called the skirted peel and stick recess adhesive design.
And what they basically do is this recess tape right up here. You can see it's sort of recessed up under the seal. And on both sides, they have these skirts. They call it a skirted peel and stick design. This feature protects the adhesive tape from collecting moisture and debris.
Also giving a nice finished look when the seal is in place. Dimensions on this again, it's 15 feet in length. The width is three quarters of an inch wide. Overall height to the top of the tabs is eleven and sixteenths of an inch tall. And this part is made in the USA. But that should do it for the review on the 15 foot long stick on hollow, half round rubber seal with the tabs for RVs and enclosed trailers..
Customer Satisfaction Score:
98% were satisfied with this product
2% of customers were not satisfied
Ratings & Reviews
Do you have a question about this Trailer Door Part?
Info for this part was:
At etrailer we provide the best information available about the products we sell. We take the quality of our information seriously so that you can get the right part the first time. Let us know if anything is missing or if you have any questions.
Thank you! Your comment has been submitted successfully. You should be able to view your question/comment here within a few days.
Error submitting comment. Please try again momentarily.