Video Transcript for Detailed Breakdown of the Replacement Angle Cylinder for Meyer Snow Plow

Speaker 1: Today, we're going to take a look at the replacement one and a half inch by 10 inch cross drill power angling cylinder for Meyer snowplows. Now, this part will replace the lift and angle cylinder on a Meyer snowplow. Does replace the Meyer part number 07968. Does have the cross drill base. The rod itself is a one and a half inch diameter rod. If we put a ruler on that, you'll see the one and a half inch diameter.

It is 10 inches long, so it does give you a 10 inch stroke with a single-acting lift cylinder.The base right here is one and five eighths inch diameter, and the pin size, the diameter of the hole that the pin goes through is five eighths of an inch. Center to center dimensions, if we measure from the center of this pin hole to this one, when it's retracted like it is now, 16 and one quarter inches. When it's extended out to 10 inches, it's 26 and a quarter inches. The port type right here on the base is a number 6SAE and the location is 90 degrees.Now, it does come with this adapter and that allows you to adapt this number 6SAE port to a quarter inch NPT connection, and this part is made in the U.S.A. But, that should do it for the review on the replacement one and a half inch by 10 inch cross drill power angling cylinder for the Meyer snowplows..