Arrives before Christmas To see if this custom-fit item will work for you please tell us what vehicle you'll use it with.
Replace a 7-way, RV-style trailer connector on your Mercedes-Benz Sprinter 3500 with this T-One harness. ModuLite reduces strain on wiring system. Brake controller adapter attaches to included body harness and lets you easily plug in your electric brake controller.
Features:
Specs:
This custom-fit T-One connector plugs into your vehicle's wiring harness, which is located behind the driver's-side and passenger's-side tail lights. You will have to remove some bumper fascia, interior paneling, vent covers, and the tail light assemblies to access this harness. Once you've plugged in the T-connector, run the body harness up to your car battery and connect the wires per the included instructions.
Once installation is complete, the 7-way connector will be stowed beneath your vehicle, near the trailer hitch. A mounting bracket (sold separately) is recommended to keep the connector secure.
It is recommended that you use a small amount of grease on all electrical connections - the plugs on your automobile and the 7-pole connector itself - to help prevent corrosion.
A ModuLite power module is built into this T-One connector. Because your vehicle runs on a multiplex wiring system, the wiring needs to be converted to be compatible with the wiring system of your trailer. This power module functions as a tail light converter to combine the brake and turn signal functions of your automobile so that they run on one wire to properly activate your trailer's tail lights. Note: This will not affect how the tail lights on your vehicle operate.
With a ModuLite, your trailer's lights will be powered without overloading your vehicle's electrical system. Because the module draws power directly from your car's battery and bypasses the electrical routes that are used by a basic wiring harness, there is virtually no draw on your tail light circuits.
This adapter hardwires to the body harness that is included in this kit. Just connect the black wire from the brake controller adapter to your car battery, and connect the white wire to a suitable ground. The remaining wires can then be easily spliced into the body harness with the included butt connectors.
This adapter is designed to plug directly into your electric brake controller. Because the harness does not hardwire to your controller, installation is not permanent. You can unplug and remove your brake controller at any time and securely stow it away.
California residents: click here
Poor design. Wires are random connected at the tail lights. Had to re pin my self, poor installation instruction , 7pin connector on instruction is wrong you need to find on your own which pattern to install them. Not worth the money, this is not plug and play.
Do you have a question about this Custom Fit Vehicle Wiring?
Info for this part was:
At etrailer.com we provide the best information available about the products we sell. We take the quality of our information seriously so that you can get the right part the first time. Let us know if anything is missing or if you have any questions.
Thank you! Your comment has been submitted successfully. You should be able to view your question/comment here within a few days.
Error submitting comment. Please try again momentarily.