Light-duty, rust-resistant bracket lets you mount a bunk board on its side and enables the board to pivot. Slotted mounting hole allows for height adjustment.
Features:
Specs:
Typically mounted upright on a boat trailer's crossmembers, vertical bunk brackets allow you to mount a bunk board on its skinny side and run the board from the front of the trailer to the back. On kayak trailers, these brackets are mounted to the trailer's frame and support bunk boards that run across the trailer.
Galvanized Steel
Galvanized steel parts are hot-dipped in zinc after being stamped. This creates a coating that is typically 3 mil to 5 mil thick. This thick, all-around coating allows galvanized steel products to provide years of use without rusting or corroding.
California residents: click here
Videos are provided as a guide only. Refer to manufacturer installation instructions and specs for complete information.
Hi everybody, Andy here with etrailer.com, and today, we're gonna take a look at the CE Smith Light Duty Galvanized Steel Vertical Bunk Bracket. Typically mounted upright on a boat trailer's crossmembers, vertical bunk brackets allow you to mount a bunk board on its skinny side and run the board from the front of the trailer to the back. On kayak trailers, these brackets are mounted to the trailer's frame and support bunk boards that run across the trailer. This light-duty, rust-resistant bracket is gonna let you mount a bunk board on its side and enable the board to pivot during loading. This is ideal for two by four or two by six bunk boards on small craft trailers. Two brackets are required per bunk board, so with this, you're only gonna get one bracket, and additional brackets are sold separately.
And the slotted mounting hole is gonna permit as much as six inches of height adjustment during insulation. So this bracket is gonna install vertically on your boat trailer's frame with a U-bolt, and this is made in the USA of 11-gauge galvanized steel that will resist rust and corrosion. By the way, galvanized steel parts are hot-dipped in zinc after being stamped. This creates a coating that is typically three millimeters to five millimeters thick, and this thick all around coating allows galvanized steel products to provide years of use without rusting or corroding, so this is going to be suitable for saltwater exposure. Let me pull out my ruler here and just go over some overall measurements here.
The overall height, we're sitting right at 12 5/8 inches tall, and the inside width, we're sitting right at an inch and 3/4 wide. And then the mounting slot dimensions, let me see if I can line this up here for you, we're gonna be sitting right at, looks like about 9 1/8 inches long, and then about half an inch wide on that slot. And then the bunk board mounting hole diameter is 7/16 of an inch. Now, check out our website here at etrailer.com if you need U-bolts, swivel brackets, or bunk boards. Well, that's gonna conclude our look today, I do hope that it was helpful for you.
Again, my name is Andy, thank you for joining me..
Average Customer Rating: 4.8 out of 5 stars (222 Customer Reviews)
Light-duty, rust-resistant bracket lets you mount a bunk board on its side and enables the board to pivot. Slotted mounting hole allows for height adjustment.
Do you have a question about this Boat Trailer Part?
Info for this part was:
At etrailer.com we provide the best information available about the products we sell. We take the quality of our information seriously so that you can get the right part the first time. Let us know if anything is missing or if you have any questions.
Thank you! Your comment has been submitted successfully. You should be able to view your question/comment here within a few days.
Error submitting comment. Please try again momentarily.