bing tracking image

Most Popular Roof Rack for 2010 Honda Accord

change vehicle


Ski and Snowboard Racks Videos

Rhino Rack Roof Rack Review - 2010 Honda Accord

Today on our 2010 Honda Accord we're going to be test fitting Rhino-Rack Roof Rack System, consisting of part numbers RRVA126B-2. Those are Vortex Arrow Crossbars, part number RRRLKVA. Those are the 500 series legs and part number DK184 and those are the clamps that will attach it to your vehicle. We already have the front one installed. You can see by the shape, it has a nice aerodynamic shape to it. Excuse me.



Thule Traverse Roof Rack Installation - 2010 Honda Accord

Today on our 2010 Honda Accord, we'll be test fitting the Thule square load bar system using the 58" bars, part number THLB58, the Thule Traverse roof rack foot pack, part number TH480, and the Thule roof rack fit kit for the Traverse foot, part number THKIT1560. With our roof rack system assembled according to the instructions, we'll grab our front bar and place it onto the front part of our roof. To ensure that we have our feet in the correct location, we need to measure 9-7/8" from the leading edge of the windshield to the closest point on our foot packs. We'll do this measurement on both sides of the vehicle to make sure that our feet are in line with each other. Once we have those in place, we can use the included tools to tighten down our clamps. With our clamp tight, we can slide the tool in place and close the lid of the foot pack.



Rhino-Rack Aero Roof Rack Installation - 2010 Honda Accord Coupe

Today we are going to show you a complete Rhino roof rack for a 2010 Honda Accord Coupe. We will be using clamp kit part number DK151 and a crossbar and foot kit, part number DA126.The first step is some small assembly on the feet. Locate the M6 by 25 millimeter security screw, the spring washer and the flat washer, as well as the M6 flat nut. Take the M6 screw, slide on the spring washer and the flat washer. Com back to the foot and slide it up through the hole so that the threads are sticking out of the top of the foot. Loosely thread the M6 square nut on the top. This is going to be hole the foot attaches to the crossbar. Locate the M8 by 50 millimeter security bolt and the M8 pivot nut. On the back side of the foot, push the pivot nut into position and make sure the angled face faces outward. Back on the front side, again we are just going to hand thread the M8 security bolt. Repeat this assembly process for the other three feet. 1:05





2010 Honda Accord Ski and Snowboard Racks Questions