Rub marks, squeaks, or crooked loading? A swivel bolster adds a little pivot so the bunk sits flush to your hull. You set the height, it spreads the boat's contact, and you'll load your boat smoother while protecting it's finish.
When a boat loads crooked or rubs the same spot every trip, it's usually a bunk alignment issue, not the hull. The slotted hole gives you the wiggle room to dial in the board angle, center the keel, and stop the scuffs. The longer 10" footprint holds the bunk steady, so it doesn't wander after a few launches or a long haul. Because the bracket is galvanized, it can live on a wet trailer without turning into a rusty mess, and the hardware will still back off when you need to service your trailer. Use one to replace a failed bracket, or grab a set and reset your bunks so loading feels smooth and predictable again.
Videos are provided as a guide only. Refer to manufacturer installation instructions and specs for complete information.
Hi everyone, Steven here with etrailer.com. Today we're taking a look at a 10 inch long tie down swivel bolster bracket for your bunk boards. Now you're gonna get quantity one just like you see before me. And as you probably know, the swivel bolster bracket provides that robust support that your boat bunks need, ensuring that you remain secure and well maintained during your transportation and storage of your boat. Now, obviously this would be tightened to whatever angle you needed, and then your bunk boards would be attached from the bottom going up. Now, do you have nice vertical slot adjustments integrated into this design.
Two and three quarter inches exactly on each of those, giving you precise customization, that way you can raise and lower it to the height you need. And if you look, you got these nice dimples here that have been stamped out when they made this, and those are non-slip dimples. They're gonna create nice holding power once you get this bolted in place on your frame. And that's gonna help hold everything in place. As these, obviously you can see this has all been hot dipped.
It's a galvanized steel, it's gonna withstand the elements. It's gonna withstand corrosion and years and years of those harsh marine environments that you're gonna be throwing at it. So again, one, quantity one, this is the 10 inch tie down swivel bolster bracket. I'm Steven. Thanks for watching.
.
Ratings & Reviews
Right on time
Do you have a question about this Boat Trailer Part?
Info for this part was:
At etrailer we provide the best information available about the products we sell. We take the quality of our information seriously so that you can get the right part the first time. Let us know if anything is missing or if you have any questions.
Thank you! Your comment has been submitted successfully. You should be able to view your question/comment here within a few days.
Error submitting comment. Please try again momentarily.