Flush Mount Grommet Bracket for 3/4" Round LED Trailer Lights - Black Plastic - Surface Mount

Video Transcript for Review of Optronics Flush Mount Grommet Bracket - OPT25KB

Hi, everybody. Andy here with etrailer.com. Let's take a real quick look at this flush-mounted grommet bracket. Now this flush-mounted bracket's going to fit 3/4-inch round trailer lights that are used in a variety of applications such as clearance, utility, or license plate lighting, and you're gonna pair it with a compatible Optronics LED for a reliable and clean installation. And before we go any further, let me try to give you some measurements here. So looking at the overall width, we are sitting pretty close to 2-1/4 inches, as you can see there, a little over 2-1/8 inches, so almost 2-1/4, and then looking at maybe what we could call the height, about 1-3/8 inches, and that center hole diameter is going to be obviously 3/4 inch.

The mounting holes are pre-drilled on each end. Let me see if I can show you the measurement on center between those holes, see if I can see that too, so we could call that at maybe 1-7/8 inches on center. So this is going to work with dozens of Optronics models, including the ones that you see there on your screen. There's quite a large listing there. And so this information can also be found on our product page if you need to refer to it again, or you could just pause the video at this point to look that over in a little more detail, but this is constructed of black molded plastic, so this is going to resist moisture, salt, and debris.

So this is gonna be ideal for long-term trailer use in all seasons, and the surface mount's going to install flush to your trailer frame or body for a sleek look with a minimal profile. Well, I think that's gonna wrap up our quick look today. I do hope that it was helpful for you. Again, my name is Andy. Thank you for joining me.

.