How Many Watts Does the Excel RV Tankless Water Heater Use

Question

Question:

Can you please tell me how many watts this hot water heater uses??

asked by: Devin H

0

Expert Reply:

The Excel RV Tankless Water Heater # EX93FR does not hook up to your battery bank or shore power for power. It is gas powered and uses 2 D-sized batteries to provide the power needed for the electric ignition. So, there is no wattage needed to use the Excel RV Tankless Water Heater # EX93FR.

expert reply by: Scott S

0

Answer 1

The Excel RV Tankless On-Demand Water Heater -with Electric Ignition, #EX93FR has an ignitor that is powered from the 2 D-cell batteries. That is the only power source, not an alternate.

view full answer...

Answer 2

Wire colors are not always the best method for determining functions. The color wires you mentioned having on your trailer are not standard, but even when looking at standard wire colors, it is always best to actually test them to ensure you are…

view full answer...

Answer 3

Since you said you have a 7-way blade connector on your Silverado I would start with the 7-Way Molded Trailer Wire Connector, part #H20046. This is an 8 ft long harness with the 7-way trailer connector. If you need a shorter harness, you can check…

view full answer...

Answer 4

The best way to get interior lights in your trailer is to have a dedicated 12 volt battery, and battery box like #329-HM318BKS mounted to the trailer. This gives you the power needed while you're not hooked to your truck. For lights I recommend…

view full answer...

Answer 5

In order to determine the torque rating for the lug nuts on your trailer you will need to know check out the chart I attached that shows all of the torque specs for all the trailer lugs available based on stud size, wheel material and wheel size.

view full answer...

Answer 6

It sounds like you are speaking of the wires for the brake magnets. If this is correct, you will need to connect one of the wires to the brake controller output wire on your trailer connector and the other wire will need to be grounded to a clean…

view full answer...

Answer 7

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

view full answer...

Answer 8

A 4-Way trailer connector has the basic lighting functions only; running lights, left turn signal and brake lights, right turn signal and brake lights, and ground. A 7-Way has these functions and a 12 volt circuit, a circuit for electric trailer…

view full answer...

Answer 9

That's a very good question, we tend to be extra cautious and say to use 10 gauge wire because that would be more than enough. When you get into longer trailers that will end up using a lot of wire the heavier gauge wire becomes more necessary.…

view full answer...

Answer 10

Even though I cannot comment specifically on the grease you used because I am not familiar with it, I can tell you the best grease for trailer bearings is a a grease with a rating of GC-LB, which just means it is made to withstand very high…

view full answer...

Answer 11

The only difference between 7-Way Utility and 7-Way RV is the color of the wires. The pin outs are the exact same so either would work just fine with the other. If you check out the picture I attached you'll see that the functions are all the…

view full answer...

Answer 12

Great question, William! The Karrier ST225/75R15 #KE63KV is a KR35 while the Karrier ST225/75R15 #AM10303 is a KR03 according to Kenda. There is a slight variation in the tread pattern and from what Kenda says about them it looks like the KR03 is…

view full answer...

How Many Watts Does the Excel RV Tankless Water Heater Use

Product Page this Question was Asked From

Continue Researching