Sheets for &quotTeddy Bear Bunk Bed Mattresses

Question

Question:

We bought a 2020 Jayco and the bunk room has a small pull down bunk. It is a Teddy Bear bunk series and the tag says its 4×26×59.5. Do they make sheets to fit this mattress?

asked by: Marsha H

0

Expert Reply:

Lippert Components, who make the Teddy Bear bunk mattresses, do not make sheets sized for the bunks, but they do have replacement covers. The closest to your measurements that we have is the Lippert # LC679284 measuring 74" long x 28" wide x 4" tall in chocolate color. Also # LC380765 for the tan color.

These mattress covers are very plush like a teddy bear, and covering them with a sheet would defeat the purpose I think. etrailer does not otherwise have linens.

expert reply by: Les D

0

Answer 1

The Curt TruTrack #C17500 and the Fastway e2, part #FA92-00-1000 are very similar. Both are rated for up to 1000 lb of tongue weight or 10,000 lbs of gross trailer weight. Both are covered by a 10 year warranty. The Curt TruTrack includes the 2-5/16…

view full answer...

Answer 2

I do have a couple different options for you, but there is no adapter for what you are needing to do. The best option would be to use an extension cord like the Mighty Cord RV Extension Cord #A10-5025EH. Since you already have 2 power cords you could…

view full answer...

Answer 3

As far as TVs that operate off of a 12v power source, the Jensen #JTV4015DC is a great choice for a larger TV. If the outlets inside your camper for electronics operate of 110v electricity because of a converter, you'll need to use the AC/DC…

view full answer...

Answer 4

If you are experiencing a bouncy ride condition with your weight distribution system that indicates that you have a WD system that is rated too high for the tongue weight of your setup. If you use a system rated to high you end up with a harsh or…

view full answer...

Answer 5

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

view full answer...

Answer 6

In order to determine the torque rating for the lug nuts on your trailer you will need to know check out the chart I attached that shows all of the torque specs for all the trailer lugs available based on stud size, wheel material and wheel size.

view full answer...

Sheets for &quotTeddy Bear Bunk Bed Mattresses

Products Referenced in This Question

Continue Researching