Parts Needed for a Ford 2020 Ranger Brake Controller

Updated 11/10/2020 | Published 11/06/2020

Products Featured in This Question

Redarc Tow-Pro Elite Brake Controller - Dash Knob - Off-Road Mode - Up to 3 Axles - Proportional

(1656)

$250.00

Redarc Plug-and-Play Wiring Harness for Tow-Pro Trailer Brake Controllers

(89)

$25.00

Curt T-Connector Vehicle Wiring Harness with 7-Way Trailer Connector

(149)

$67.13

Universal Installation Kit for Trailer Brake Controller - 7-Way RV and 4-Way Flat - 10 Gauge Wires

(3335)

$124.31

Question:

Do you carry the towing pack to brake controller part number vKB3Z-2C006-a. Ford says this is the only one for that vehicle.

asked by: James A

Expert Reply:

We have the parts you're looking for!

It looks like Ford is using the Redarc Tow-Pro Elite, part # RED44FR, as the brake controller for a 2020 Ford Ranger.

If your Ranger has a factory 7-way, then the harness you need to install this brake controller is the Plug-and-Play Harness, part # 331-TPH-007. This will allow you to easily hook up the Tow-Pro Elite. I've linked to a video review of this harness for you to look at. We also have the controller and harness bundled together, which I've linked to below as well.

If you do not have a factory 7-way, then you will need additional components for this setup. On top of the two parts above, you will need the Universal Installation Kit, part # ETBC7. I've linked to a video installation of this kit on a 2011 Ranger. It will plug into the 4-pole on your vehicle and give you a 7-way.

If you do not have that 4-pole, use the Curt T-Connector, part # C56431, instead. I've linked to a video installation of this 7-way on a 2020 Ranger.