Replacement Parts for the Bulldog Powered Drive Trailer Jack part BD500199
Updated 08/19/2020 | Published 06/27/2019 >
Products Featured in This Question
Question:
Purchased a Bulldog 500199 jack in 2016. Love it, use it often. Unfortunately, the connector went bad little black box under the cover with two wires. Is there a replacement part available?
asked by: Merry B
Expert Reply:
I have attached for you a list of the replacement parts that are available for the Bulldog Powered Drive Trailer Jack part # BD500199. I am not sure which part in particular that you are referring to but if it is not listed below then you would unfortunately have to replace the jack. The Ultra-Fab Electric A-Frame Jack part # UF38-944014 would be a good cost effective replacement for this if needed.
Replacement Extend and Retract Switch part # BD500363
Replacement Manual Override Crank part # BD500203
Replacement Manual Override Cover part # BD500201
Replacement Level Assembly part # BD500193
Replacement Light Switch part # BD500362
Replacement Spring Loaded Pull Pin part # BD500388


Eddie C.
8/9/2020
I have a Bulldog 500199. I need everything except the motor. Is it possible to find the jack w/o the motor?

Product Page this Question was Asked From
Bulldog Powered Drive Trailer Jack - Drop Leg - A-Frame - 22" Lift - 4,000 lbs - Black
- Camper Jacks
- Pop Up Camper
- Teardrop Camper
- Travel Trailer
- A-Frame Jacks
- Steel
- 3001 - 4000 lbs
- Electric Jack
- 22 Inch Lift
- Bolt-On
- 1 Jack
- Bulldog
more information >
Featured Help Information
Instructions
Continue Researching
- Shop: Bulldog Powered Drive Trailer Jack - Drop Leg - A-Frame - 22" Lift - 4,000 lbs - Black
- Q&A: Replacement Drop Leg for Bulldog Powered Drive Trailer Jack # BD500199
- Shop: Replacement Drop Leg for Bulldog Round Trailer Jack or Powered Drive Camper Jack
- Search Results: trailer jack pads
- Video: Race Ramps Combo Ramps Spec Review
- Shop: Race Ramps Trailer Loading Assist Ramps - 6-1/4" Lift - 74" Long - Qty 2
- Video: Review of Bulldog Replacement Manual Override Cover Powered-Drive Trailer Jack - BD500201
- Search Results: bulldog electric jack
- Shop: Replacement Manual Override Cover for Bulldog Powered-Drive Trailer Jacks - Qty 1
- Shop: Replacement Pad for SnapPad Jack Stand Pad System - 8" Round Jack Foot
- Shop: Bulldog Round, A-Frame Jack Drop Leg and Pull Pin Assembly
- Video: Complete Breakdown of the Hopkins Cross-Check Trailer Level
- Shop: Replacement Spring Loaded Pull Pin for Bulldog 4,000-lb Electric A-Frame Trailer Jacks
- Video: Interaction with the Race Ramps Trailer Loading Assist Ramps
- Q&A: Replacement Bubble Level Needed for the Bulldog Powered Drive Trailer Jack # BD500199
- Video: An In-Depth Look at the Bulldog Powered Drive Trailer Jack
- Q&A: Spring Loaded Pull Pin Compatibility For Round A-Frame Tongue Jacks
- Q&A: What Jacks Does BullDog Spring Loaded Pull Pin BD500388 Fit
- Search Results: 2 5 16 hitch ball cover
- Search Results: rv levels
- Search Results: angled plunger trailer door holders
- Search Results: trailer hitch ball cover
- Search Results: hitch ball cover 2 5 16
- Q&A: How To Load And Unload A 2007 Mazda Miata MX-5 Without Scraping
- Video: Wheel Masters Level Master Trailer Bubble Level Review
- Video: Checking Out the Stromberg Carlson Electric Trailer Jack
- Q&A: Can Two 6 Volt Trailer Batteries Power the Stromberg Carlson Electric Jack
- Q&A: Trailer Jack Recommendations for a 10,000 Pound A-Frame Trailer
- Article: Trailer Tire Sizing
- Article: Trailer Wiring Diagrams
Kevin D.
4/17/2020
I have a jack 500199 and the screw broke I cant find a screw or a screw and nut assembly. Can you help?