Troubleshooting Out of Stroke Error on LCI Ground Control Auto Leveling System
Products Featured in This Question
Question:
Our 2014 Columbus 320rs auto leveling device is show a message: Error—- out of stroke. We do not have truck here so we canno hook up. Rv needs to auto leveler to work- is not level now. Do you have any advice. I’m afraid to punch again. It also sounds an alarm if we don’t turn unit off. Thank you
asked by: Crystal
Expert Reply:
The Out of Stroke error message on the Lippert Ground Control system, such as # LC358590 indicates the jack has extended as far as it will go and has maximized it's extension.
To clear the error you can extend all of the jacks in the system at least 6 inches. Then press and hold the retract button until the jacks start to retract. All of the jacks should fully retract and the error should be cleared. You would then either need to move your camper to a more level location so your jacks won't overextend or use leveling blocks like the Stackers Leveling Blocks for Trailers and RVs - 1-3/8" x 8-1/8" - Qty 10 # A10-0918 under the leveling jacks.
Obviously you need to have a truck to do that, so you will either need to borrow another camper's truck if available or wait it out if your camper is safe yet not leveled.

Product Page this Question was Asked From
Lippert Ground Control 3.0 Electric 5th Wheel RV Leveling System w Touchpad - 4-Point Set
- Camper Jacks
- 5th Wheel Camper
- Stabilizer Jacks
- Steel
- 10001 lbs or More
- Electric Jack
- 36 Inch Lift
- Bolt-On
- 4 Jacks
- Lippert
more information >
Featured Help Information
Instructions
Miscellaneous Media
Continue Researching
- Q&A: How to Clear Out-of-Stroke Error Message on Lippert Ground Control System LC358590
- Q&A: Can Lippert Ground Control 3.0 System Have Rear Jacks Mounted at Different Distance from Front Jacks
- Q&A: How to Determine if Lippert Ground Control 3.0 Will Fit 5th Wheel RV
- Q&A: Replacement I-Beam Jack Bracket for Lippert Ground Control 3.0 Leveling Systems
- Q&A: Mounting Plate Height of Replacement I-Beam Jack Bracket for Lippert Ground Control
- Q&A: Clearance Required Around Rear Jacks of Lippert Ground Control 3.0
- Q&A: Replacement Jack Motor For The Lippert Ground Control 3.0 4 Point System
- Article: 4 Steps to Choosing Your 5th Wheel Pin Box
- Article: 30-Amp and 50-Amp RV Service: What's the Difference?
- Article: 5th Wheel to Gooseneck Adapters
- Article: Ram Trailer Tow Prep Package
- Article: Gooseneck Trailer Hitch Information and Review
- Article: Guide to Choosing the Best Truck for 5th-Wheel Towing
- Article: How to Raise Your Travel Trailer Height