Troubleshooting Trailer Brakes That Will Not Disengage
Question:
My electric brake on camper is stuck in the on position. I was adjusting and the star wheel will not roll up or down. I am not able to remove the hub since brakes are on. Any ideas?
asked by: Rob
Expert Reply:
It sounds like you may be having some wiring issues; but first, start by checking your connectors to see if there is any corrosion that may be hampering their functionality and keeping your brakes engaged. To disengage your brakes, cut the power wire and that should disengage them. Then go over the wiring to try and look for any that are crimped, broken, or otherwise damaged. If you cut the wires that are feeding your brakes power and they still do not disengage, you will need to go to a local trailer or mechanic and have them attempt to diagnose the issue.

Product Page this Question was Asked From
Dexter Electric Trailer Brake Assembly - 12" - Left Hand - 6,000 lbs
- Accessories and Parts
- Trailer Brakes
- Electric Drum Brakes
- LH
- 6000 lbs
- Brake Assembly
- Manual Adjust
- 12 x 2 Inch Drum
- Dexter
more information >
Continue Researching
- Shop: etrailer Electric Trailer Brakes - 12" - Left/Right Hand Assemblies - 5,200 lbs to 7,000 lbs
- Shop: Mounting Bolts and Hardware for 12" Brake Assemblies
- Article: How to Adjust Your Trailer Brakes | The Ultimate Guide
- Search Results: accessories
- Search Results: brkh12
- Video: All About the Grease Seal
- Article: Trailer Maintenance Schedule
- Q&A: What Ohms Should Trailer Brake Magnets Be?
- Q&A: Troubleshooting Weak Braking on One Side After Installing New Trailer Brakes
- Video: 3500lb Trailer Idler Hubs Direct Comparison
- Shop: Trailer Wiring
- Shop: etrailer Hitch Pin Alignment Collar for Hitch Accessories - 2" Hitches
- Shop: Yakima LongHaul RV Bike Rack - 4 Bikes - 2" Hitches - Silver
- Article: How to Measure for Trailer Hitch Drop
- Search Results: redarc mounting panel
- Video: Redarc Tow-Pro Liberty Brake Controller Review RED24FR
- Video: Installation: T-One Vehicle Wiring Harness with 7-Way Trailer Connector on a 2022 Nissan Frontier
- Shop: Brake Controller
- Shop: Replacement Magnet Kit for 12" Electric Trailer Brake Assemblies - 5,200 lbs to 7,000 lbs
- Q&A: Troubleshooting Redarc Tow-Pro Liberty Calibration
- Q&A: Troubleshooting Electric Brakes that Wont Fully Disengage and Heat Up Drum Assemblies
- Shop: Hub Bearing Kit for Lippert, Dexter, and AL-KO Axles - 3,500 lb with #84 Spindle
- Shop: #84 E-Z Lube Spindle w/ Brake Flange for 3,500-lb Trailer Axle - 1-3/4" Diameter
- Video: Let’s Check Out the Washer For 1" Spindle
- Shop: Trailer Hitch
- Video: Changing Brakes Demonstration
- Q&A: How To Tell If I Have An EZ Lube Axle
- Search Results: replacement spindle washer
- Search Results: cotter pins
- Video: Spindle Nut Kit for EZ Lube Axles: The Breakdown