Differences Between Phoenix USA # QT765CHN and # QT865CHN Quick Trim Hub Covers

Question

Question:

What is the difference between the qt765 and qt865? They both say chrome wheel cover.

asked by: Rachel

0

Expert Reply:

Both QuickTrim Trailer hub covers are for wheels with 8 on 6-1/2 bolt patterns, but the # PXQT765CHN is for 13/16 inch lug nuts and the # PXQT865CHN is for 7/8 inch lug nuts.

expert reply by: Mike L

0

Answer 1

The Phoenix USA QuickTrim Hub Cover - 8 on 6-1/2" Bolt Circle - ABS Plastic - Chrome - Qty 1 #PXQT765CHN is 4-7/8" on the inside and 4-1/8" on the top/outside when measured.

view full answer...

Answer 2

From previous questions I'm fairly certain your seal 212337313TB is the same as the #GS-2250DL which has an inner diameter of 2.250 inch and outer diameter of 3.376 inch.

view full answer...

Answer 3

There are two common grease seals used on 7,000 lbs axles, part #GS-2250DL which has a 2.250" inner diameter and part #GS-2125DL which has a 2.125" inner diameter. The former is more common and used on newer trailers. They are both double…

view full answer...

Answer 4

Hey Fili, so we do have solutions for air bag kits on trucks that are lifted like yours but it comes down to knowing by how much the vehicle was lifted to pick out the correct spacer. So what is your best solution is to go with a Firestone air bag…

view full answer...

Answer 5

In order to determine the torque rating for the lug nuts on your trailer you will need to know check out the chart I attached that shows all of the torque specs for all the trailer lugs available based on stud size, wheel material and wheel size.

view full answer...

Answer 6

The distance on center that you want have between fifth wheel rails is right at 22 inches. Typically we recommend you place the rear edge where the installation instructions recommend and then use the fifth wheel hitch to place the front rail. But if…

view full answer...

Answer 7

The Phoenix USA #PXQT965CHN QuickTrim Hub Cover fits wheels with an 8 lug on 6-1/2 inch bolt circle with 1-1/16 inch lug nuts, regardless of the wheel stud size. If your existing wheel meets those parameters, the #PXQT965CHN QuickTrim Hub Cover will…

view full answer...

Answer 8

Hey Matthew, so we have a hitch that fits your 2011 Mini Countryman like with the Curt #C11333 but the hitch part number you referenced does not fit your vehicle.

view full answer...

Answer 9

Hey Doug, our fitguide is sometimes a bit confusing, but the Timbren Rear Suspension Enhancement System #TMBRSP35A you were looking at fits the 2023 Mercedes Sprinter 3500xd AWD/4WD (fits 2wd or 4wd/AWD) if it is a motorhome. If it is not a…

view full answer...

Answer 10

It depends on what size lug nuts you have. There are two options and I have listed them both below: 13/16" Lug Nuts - Phoenix USA QuickTrim Hub Covers item #PXQT765CHN 7/8" Lug Nuts - Phoenix USA QuickTrim Hub Covers item #PXQT865CHN Both…

view full answer...

Answer 11

The second speed is going to be like a "granny low" gear that is easier to crank but requires a lot more turns to get it to move. The single speed jacks would have the higher speed of a 2 speed jack.

view full answer...

Answer 12

For a trailer that will be used in saltwater, the best option for rotors, hubs, and calipers is those made of stainless steel. Galvanized coating is the second best option for saltwater, and then dacromet coatings, which provide extra resistance to…

view full answer...

Differences Between Phoenix USA # QT765CHN and # QT865CHN Quick Trim Hub Covers

Product Page this Question was Asked From

Featured Help Information

Miscellaneous Media

Continue Researching