Welding Latch Pin Installation for Securing Trailer Ramp
Question:
I watched the video on the part and I still dont understand how it is welded in order for it to work. I want to use two of the latch pins to secure the tailgate on my 5 x 10 utility trailer. Any possibility of a picture of this application?
asked by: Ric H
Helpful Expert Reply:
I attached a picture that shows how the # SL58W will install on a trailer with a ramp. I used arrows to point out the latches and the holes that it will fit into when folded up and latched.
I also attached a picture that shows where you would weld the # SL58W to your trailer and where you would drill the hole in the ramp so that the pin would insert into it and secure it.
Product Page this Question was Asked From
Continue Researching
- Q&A: Will the Master Lock # 1481DAT Work With My Demco eZ-Latch # DM15945?
- Q&A: How to Determine Between 5 on 4-1/2 and 5 on 5 Bolt Patterns for Hub Covers
- Q&A: Door Hinge Bracket with 4 Inch Width
- Q&A: Does Dump Door Hinge PLR1904-Z Have Weight Capacity
- Q&A: 7-Way Wiring Diagram to Use When Installing New 7-Way Plug
- Article: Trailer Lighting Requirements
- Q&A: Replacement Latching Pin for Trailer Tailgate that Measures 5-3/4 inches
- Q&A: Dimensions of Polar Steel Dump Door Hinge PLR1904-Z
- Article: Breakaway Kit Installation for Single and Dual Brake Axle Trailers
- Article: How to Accurately Measure Trailer Leaf Springs
- Article: How to Raise Your Travel Trailer Height
- Article: 7 Common Questions Everyone Has About Trailer Tires
- Article: Trailer Jacks