2004 Suzuki 700 Twin Peaks ATV Winch Mount

Winch mounting bracket #BDW15148 is designed to fit a 2002 Arctic Cat 500 Manual 4x4 or Automatic 4x4 and Automatic TBX 4x4. We only carry this one bracket for 2002 Arctic Cat 500 models.

For your 1997 Suzuki King Quad 300 the Bulldog Winch ATV mount part #BDW15135 that you referenced is a confirmed fit.

I wish we had an exact figure we could give you on that. But the general rule of thumb is that anytime you use a hitch extender you end up cutting the capacity of the hitch by 50 percent. This is due to the added leverage like you mentioned as well…

Hitch extenders like the etrailer part #e88YR reduce hitch capacity for two reasons. One is the length like you mentioned and the other is amount of additional movement that they introduce to the hitch setup which puts quite a bit of stress on the…

The Curt ATV Towing Starter Kit #C45038 is designed to work on any ATV that has a tongue area for mounting a hitch ball with a 3/4-inch hole diameter. The receiver portion with the tow strap loop uses an included 3/4-inch bolt to install in that…

I do have a solution for you, however, we not offer winch mounting plates specifically for Badlands Winches. Most winches use the industry-standard bolt pattern, but you will want to verify fitment with Badlands or drill your own mounting holes if…

Actually, the P3 now has the upgraded axis accelerometer like the P2. The Tekonsha P3 Trailer Brake Controller #90195, will work with both electric over hydraulic brakes on the trailer as well as electric brakes. It has a menu option on the display…

In order to pick out the correct tires and wheels for a trailer you are going to need to know some information on your trailer first. First thing you will want to know is the bolt pattern of the hubs on your trailer. I attached an FAQ article on how…

The Trailer Hitch Receiver Mounted Forged Tow Eye, part #TR63045, has a gross trailer weight capacity of 10,000 pounds. This represents the weight of the loaded trailer. With the Trailer Hitch Receiver Mounted Forged Tow Eye you can pull a trailer…

As you've discovered, a 2 inch receiver doesn't always measure exactly two inches by two inches. There is a manufacturing tolerance involved that allows the receiver to be a few hundredths of an inches larger or smaller than 2 inches, but…

I went to the warehouse and measured the Bulldog Winch Custom-Fit Steel Winch Mount, part #BDW15151. The mount measures 8-inches tall, 6-1/4 inches wide, and 5 inches deep. The mounting holes on the bottom bracket are 2-3/4 inches center to center.…

The correct custom fit winch mount for a 2014 Polaris 570 Sportsman is the Bulldog Winch Custom-Fit Steel ATV Winch Mount part #BDW15151 which contains the industry standard winch mounting pattern so it will work just fine with the Badlands 3,500 Lb…