2014 Chevrolet Sonic Vehicle Lights

Hi Robert, To install your Putco Blade LED Tailgate Light Bar #P22KR you'll need to just remove the tail lights so that you can get access to the back…

Yes, the 921 LED Bulbs #ARC48FR would be a compatible replacement for a JRP1007B light bulb. With this light being LED it will have a lower wattage and amperage draw for a cooler, brighter light that requires less energy to run.

According to my research we do have a few options that will work as a replacement for your E333645 LED light: Cool White - 180 Lumens/5,500 Kelvin #DI56VR - 165 Lumens/5,500 Kelvin #DI86VR Warm White - 180 Lumens/3,500 Kelvin #DI29VR - 165…

I did some looking and found that the 46210 and 46845 hubs you currently have use the same #L68149 inner bearing and #L44649 outer bearing. However, as we do not carry the Tie Down Engineering Vortex hubs, I cannot say what all will fit them,…

The Dexter 8-427 hub is no longer available. Even looking through Dexter's site the only references to it are replacement bearings. You can use a wheel with…

A typical tire inflator will have a CFM rating of around 1.5 to 2 CFM, with a majority of the little cheap ones being less than 1 CFM. The higher the rating the faster…

We can get your 2024 Chevy Silverado 1500 4x4 set up with a complete system for flat towing, and I'll go ahead and list out all the parts you need to make…

Hello again Michelle. The Saris Glide EX Bike Rack #SA774 will indeed fit a 2023 Hyundai Tucson with a class 3 hitch. The tilt feature will allow the hitch to open and close normally. Saris bike racks are definitely good quality. They are all made…

Dexter part 10-41 is a grease seal for a mobile home utility hub. It has a specified inside diameter of 1.938-inches and an outside diameter of 2.523-inches. The nearest match we offer is the Redline part #10-40 which is a single-lip seal that has…

Hey Jerry, the install of the Aries Bull Bar part #AAB35-4015 do require you to permanently remove the tow hooks to install. It looks like the similar Westin Ultimate Bull Bar part #32-3645 does allow you to keep them though.

I recommend the Dexter Zinc-Plated Model 10 Brake Actuator w/ Drop to replace your current Tie Down actuator. You will need either the Disc Brake Actuator #T4750620 or Drum Brake Actuator #T2478100. These both have a similar design as your current…

Hey Terry, this is a great question but I would assume due to the age of your SMI system and fact you have a hybrid now that has the different braking system it…