Hi Jose; the slight curve on the #DT42GR is just how Draw-Tite decided to design the hitch. The same is true for the straight cross tube of the Curt #C96NR. The different designs don't really have an advantage over each other and they have the…
The Draw-Tite Max-Frame Trailer Hitch Receiver #DT42GR is our best hitch for your 2024 Jeep Grand Cherokee. This receiver will hide behind the removable factory rear bumper fascia so it is hidden when not in use and will not reduce ground clearance.…
No, we do not. There are two aftermarket hitches for the 2023 Jeep Grand Cherokee L and neither one of them will allow a 20" spare tire to be mounted once installed. They are the Curt item #C96NR and the Draw-Tite item #DT42GR. Please note that…
Since both hitches are rated for higher than the capacity of your 2024 Jeep Grand Cherokee the capacity really isn't as important of a factor. The smaller factors like the length of the receiver tube and how the safety chain loops sit would be…
Yes, you are going to be able to reinstall the removable bumper cover after you install the Draw-Tite Trailer Hitch Receiver #DT42GR on your 2023 Jeep Grand Cherokee.
Hey Ray, so we have the part #18159 which would work great to secure the 7-way of the #ETBC7L that you'll be installing with the Curt Echo #C51180. It's also pretty easy to install too.
There are a few differences between the Universal Installation Kit part #ETBC7 and the 7-Way RV Upgrade Kit part #ETBC7L. The biggest one is that part #ETBC7 comes with both the power and brake output wire you will need to run to the cab/battery…
From what I'm seeing it looks like the Draw-Tite Max-Frame Trailer Hitch Receiver #DT42GR (76595), which replaced the 76545, not only got a higher class rating, but it also looks like the crosstube is closer to the bolt holes as well which might…
The Curt hitch part #C96NR and the Draw Tite hitch part #DT42GR both fit the 2022 Jeep Grand Cherokee L model that has the third row seating. Since the Draw Tite has higher towing capacities and has a trailer wiring mounting bracket built into it…
If you are referring to the 12 volt pin that is located in the 1 o'clock position on the 7-way trailer connector then there should be 12 volt power feeding from the vehicle to the trailer on that pin. This means that if you test the 12 volt wire…
Dave, you could use either the Black #SM96MJ or Gray #SM46MJ Port inlet and add the Coax #SM76MJ and Ethernet #SM38MJ inputs to get the connector you are looking for.
The Demco Battery Disconnect Switch #DM63FR has the following ratings: - 300 Continuous Amps Rate - 500 Cold Cranking Amps I confirmed this with my contact at Demco.
