Videos
for Keystone Sprinter Limited Travel Trailer Owners
Help Articles
for Keystone Sprinter Limited Travel Trailer Owners
Expert Answers
for Keystone Sprinter Limited Travel Trailer Owners
Hey Kelly. The Lippert 2" Accessory Receiver Hitch for Up to 66" RV Frames item #LC78DX does not come with installation hardware. I checked with Lippert and they said that this hitch is intended for use with RVs that are prepped for a…
view full answer...So long as a hub uses the correct bearings that match the dimensions of the spindle that is on the axle there is no worry about using two different brands of products, such as a Dexter hub on a Lippert axle. That in itself is not a concern. When a…
view full answer...Yes, the temperatures you mentioned are normal. If you were getting over 200 degrees that would be a bad sign. But typically if all of the hubs are the same temperature you're good and it's only really an issue if one of the hubs is hotter…
view full answer...The psi and temperature are going to change based on the tire and the temperature outside for your ST225/75R15 tire like the Westlake #LHWL304. So it is not surprising at all that the psi climbed based on your long trip as well as the significant…
view full answer...The E-Track part #E19148 that you referenced is not specifically designed for a recess mount although if you wanted to come up with a way to do that you certainly could. A manufacturer was here recently and they had recessed mounted E-rack in their…
view full answer...The process to install the Pulse Preventer for Electric Brake Controllers part #5501 on a vehicle with factory brake controller port entails locating the stop light switch wire in that harness (usually red) and splicing into this between the brake…
view full answer...The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…
view full answer...A 4-Way trailer connector has the basic lighting functions only; running lights, left turn signal and brake lights, right turn signal and brake lights, and ground. A 7-Way has these functions and a 12 volt circuit, a circuit for electric trailer…
view full answer...Hey Jonathon thank you so much for all of that additional information! To haul your bikes behind your class C Sprinter motorhome, while flat towing your Mini, I recommend the Hollywood Racks RV Rider Bike Rack item #HLY64FR and the Roadmaster Dual…
view full answer...Hi Paul, you’re definitely on the right track here, and I can help you narrow this down with confidence. With your tandem 3,500 lb Dexter axles and 33 inch spacing, both the Dexter EZ Flex part #K71-652-00 and the Lippert Road Armor part #LC53CK are…
view full answer...According to Blue Ox, it'll take an experienced installer about 4 to 5 hours to complete the installation of their #BX1128 Base Plate Kit on a 2016 Jeep Grand Cherokee. The install isn't what I'd call super-difficult, but the installation…
view full answer...Hi Glen, It will depend on what the GVWR (gross vehicle weight rating) is of your trailer to determine which B&W 5th wheel to gooseneck adapter will work best for you. Fifth wheels and gooseneck trailers go off of pin weight instead of tongue…
view full answer...
























