Custom Fit 2017 Ford F-350 Super Duty Accessories

Hey Tony! Sorry but there's no way to attach a set of 5th wheel rails to a flat bed with a recessed ball. The gooseneck will be in the way and you won't be able to attach the 5th wheel brackets to the frame. The only solution I have for you…

Hello Aaron, Now you say you are pulling a heavy race trailer, so it sounds like you need some heavy duty airbags to go with it. The Firestone Ride-Rite Red Label Extreme Duty Air Helper Springs - Rear Axle #F2709 are good for leveling a load up to…

To know if your 2017 Ford F-350 has an in-bed puck system installed you'll just need to look and see if you have four rounded attachment points (usually covered up when not in use, like in the attached picture). If you don't see these in your…

We have run into this quite a few times in the past, and the best option will be replacing the Lance 7-pin connector with a standard 7-way blade connector like the #PK12706. This will give you a standard 7-way connector to plug into the factory 7-way…

I wish I had something direct that I could recommend for you, but honestly your best option would be to find a local vehicle-side trailer wiring connector, remove your current one and then wire it up to match the connector on the trailer you have. In…

Joe, the WS Aero Hitch 6" Drop Hitch w/ 2" Shank #WS67MR is available with a 4" #WS54UR, 10" #WS42RR, and 8" #WS45RR drop length.

The only difference between the Firestone Ride Rite Red Label 5000-lbs Air Bags #F35FV and the 7500-lbs Air Bags #F95FV is the material that they are constructed with; both air bags will be the same size, but the 7500-lbs air bags are constructed…

If you have a trailer wheel that has a 6 lug setup you are going to have a bolt pattern of 6 on 5-1/2 inches. This is the standard 6 lug wheel bolt pattern that trailer rims have. If you are unsure you can check out the help article I attached that…

If the microwave you have is the High Pointe 520EC028KD7S the correct replacement would be the High Pointe part #HP49ZR.

The OEM prep package consists of 4 "pucks" in the bed of the truck that will allow you to drop in puck style hitches for easy installation and removal, that gives you a completely clear bed when not in use. The B&W Companion OEM 5th…

The Dexter 8,000-lb axles are typically 3-1/2" in diameter, whereas the Roadmaster Comfort Ride Shock Absorbers, part #RM-2460, only fit on 3" diameter axles (which is standard for 5200 - 7000-lb axles). So, unfortunately, you will need…

There are a few different tie-down fits for your 2017 Ford F-350 Super Duty with an 8' bed, but it all depends on if you have a board or step underneath the truck bed, and if you have a factory hitch or not. When aluminum is available it is a…