Hey Jeff, best option for that would be the Redarc Tow Pro Liberty part #RED52VR which only puts a small knob on your dash and also comes with a universal wiring harness to bypass the vehicle wiring like it sounds like you are wanting to do.
Yes, it does Michael! The Toyota specific mounting panel item #331-TPSI-002 is included with the Redarc Tow-Pro Liberty Brake Controller w/ Custom Harness item #RED82CR. The custom harness included with this kit will allow you to have a simple plug…
Hello Jonathan, Great question. You are going to want the #RED98CR as it will be both the brake controller and the plug-n-play pigtail for the 2008 Toyota Tundra. The #RED82CR is just the brake controller by itself. Happy New Year! May 2025 be your…
A 4-Way trailer connector has the basic lighting functions only; running lights, left turn signal and brake lights, right turn signal and brake lights, and ground. A 7-Way has these functions and a 12 volt circuit, a circuit for electric trailer…
While it is very possible for the converter on a Curt T-Connector like part #C55513 or #C56513 for your 2008 Toyota Tacoma to go bad, it is important to do some troubleshooting before replacing parts because if the problem isn't the converter…
Hey Shannon, thanks for reaching out! Sounds like you're looking for the Thule Xsporter Pro #TH500XTB-THXK3 for your 2008 Toyota Tacoma with the Deck Rail System. This is adjustable up and down as well as along the Deck Rail System so you get the…
I have included photo that shows the location of the brake controller port on a 2007 Toyota Tacoma. We have not had a 2007 model that had a tow package to determine the plugs exact location for that model year. According to my contacts at Tekonsha,…
The reason you would not want to install a 30 amp fuse or circuit breaker in a 4 brake magnet application, when installing a Prodigy P2 brake controller, #90885, is that the extra amperage required to break the circuit could cause an issue with the…
That will depend on the amount of brake axles your trailer has. . The 20 amp breaker like #9506P is for 1 and 2 axle brakes, and the 30 amp like part #38630 is for 3 and 4 axle brakes
Yes, the Curt Class III Trailer Hitch, #13323, will fit on your 2007 Toyota Tacoma PreRunner. This hitch fits all models of the 2007 Tacoma. We had a customer install this hitch on their PreRunner model last month and commented that it works great.…
The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…
I think you are going in the right direction. I would definitely replace the 14 gauge wire going to the trailer brake magnets with 10 gauge wire or larger. Usually larger than 10 gauge is hard to get into the trailer connector though. I would also…
