Custom Fit 2007 Toyota Sienna Accessories

For your 2009 Toyota Sienna, I recommend the Curt Trailer Hitch Receiver - Custom Fit - Class III - 2" #C13105 you referenced. From the lowest point of the hitch receiver you will have about 8-1/2 inches of ground clearance. The inside top of…

The main differentiation between the available Class III hitches is how they'll appear once installed. The etrailer brand #e98837 and the Draw-Tite #75237 will have the entire hitch visible under the rear bumper. In contrast, the Draw-Tite #76112…

All of the trailer hitches for your 2006 Toyota Sienna are going to sit in the same area. You'll get slightly better ground clearance from a hitch with an 1-1/4" receiver and when the installed the Curt #C12065 and Draw-Tite #36513 Class II…

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

We can get you everything you need for towing with your 2017 Toyota Sienna XLE. By plastic shield, I believe you are referring to the appearance panel underneath the Sienna, and that will have to trimmed a bit in each of the hitches available for the…

The etrailer hitch #e98837 weighs 40 lbs and does fit your 2005 Toyota Sienna. I attached an install video for this hitch on a similar 2006 Toyota Sienna as well.

A 4-Way trailer connector has the basic lighting functions only; running lights, left turn signal and brake lights, right turn signal and brake lights, and ground. A 7-Way has these functions and a 12 volt circuit, a circuit for electric trailer…

The Curt Trailer Hitch Receiver #C13105 that you referenced, which is confirmed to fit your 2018 Toyota Sienna, uses six M12-1.25 x 40 hex bolts and six 1/2 inch conical toothed washers for installation. We can indeed provide you with this hardware…

On a vehicle that sits as low in the rear as your 2011 Toyota Sienna there are no hitches available that are going to give you excellent ground clearance, but the Draw Tite Hitch part #75237 that you referenced installs right under the rear fascia of…

You would want to hitch your trailer up to your tow vehicle and then inflate the bags of the Air Lift Kit part #AL60769 to the point where the vehicle is leveled. So to long story short...inflate the bags after hitching up.

For your 2002 Chevrolet Suburban 4 wheel drive I recommend the Air Lift 1000 Air Helper Springs for Coil Springs - Rear #AL60769 you were looking at. This kit will provide up to 1000lbs of load leveling support to your rear suspension when towing a…

To wire your 2009 Toyota Sienna for towing, I'd recommend the Curt #C55580 wiring harness. I'll link you to an install video showing a similar wiring harness from another manufacturer being installed on a 2008 Sienna. The install procedure…