Custom Fit 2001 Dodge Dakota Accessories

If you have a vehicle specific wiring harness for a brake controller then that would indicate that you have a factory tow package and subsequently would already have a 7-way at the back of your vehicle. The universal 7-way connector #ETBC7 is meant…

You could use the Thule M8 T-Bolt part #853-5715 which is just a little longer at 26 mm.

A 4-Way trailer connector has the basic lighting functions only; running lights, left turn signal and brake lights, right turn signal and brake lights, and ground. A 7-Way has these functions and a 12 volt circuit, a circuit for electric trailer…

The two sizes you mentioned are different balls. The larger size typically has higher capacities and fits couplers that are designed for it's size. The 2 inch size is typically seen in lighter duty applications. You have to match the correct size…

Since you already have a 4-way connector on your 2018 Toyota Highlander you need to use one of our adapter kits to convert it to a 7-way. If the trailer doesn't have brakes you only need to power its lights and the battery so you can use part…

For the 2003 Dodge Dakota, there are specific trailer hitches that will fit all models INCLUDING the quad cab. Take a look at Curt hitch #C13145. The instructions I have linked do specify that it fits 2 door and 4 door models. I also recommend the…

The primary differences between the Curt #C13280 and #C13145 are cosmetic. The C13280 would be mainly concealed behind the rear bumper, while the C13145 would be visible. The hitches have identical capacities, so either would work great from a…

A boat trailer jack that uses a snap ring works differently than one that is a bolt-on, like yours, because the mounting bracket for a bolt-on jack and snap-ring jack will be different. Because you have a Fulton 1,200 lb bolt-on jack, I assume your…

I have a couple close but not perfect to your measurements. The 2" Lubed Dust Cap & Rubber Plug - 1.99" part #DC200L-DCRP is an extremely common cap size found on a lot of trailers. Sometimes the hub will have a small bevel on them that…

The Thule replacement M8 T-bolt #853-5715 T-bolt head measures 3/4 inches. The threaded part of the t-bole is 1-inch long, and it has a .30 inch diameter. I have attached a photo of the 853-5715 with the dimensions noted you can check out.

I went to our warehouse and pulled a couple of the Dexter Hub And Drum Assemblies, part #84556UC3. I took measurements between the bolts on the drums and took a photo you can check out. The measurement I got was 2.997 as the photo shows on the…

Thank you for providing the inner diameter of the two bearings; that is especially helpful when trying to determine which replacement parts are going to work. Even though we can confirm the bearings are a fit, you'll also want to make sure that…