Review of etrailer Replacement Rod and Nut - e58AV Video

Good news! I was able to get a exploded diagram as well as a set of instructions on how to replace the rod and gears #TJD-12000-RODNUT in the #12000 Series Ram Jacks made after 2012. I have attached them to this page for your convenience. Basically,…

I do have an option for you but we don't offer a replacement jack screw for the Pro Series 12K Square Jacks. Therefore, if yours is faulty then the jack will need to be replaced. For this, we offer the Pro Series Square Jack part #PS1400960376…

We may be able to help you find the replacement parts you need for your 12K-rated Fulton jack but a part number for the jack and a photo would help. I did check all 12K-rated jacks and landing gear that we carry and none is the Fulton brand. I did…

Pacific Rim is the manufacturer of the RAM jacks. You can verify the Replacement Rod and Nut #TJD-12000-RODNUT you found is the correct part by confirming your jack is 3-1/2" by 3-1/2" square and the 1" rod is 17-3/4" long. If you…

If your trailer has 12k capacity Bulldog brand jacks then yes, the part #BD500217 would be the correct part you'd need. If instead they are Bulldog 10k jacks you'd want the part #BD500250 instead.

Hey Matt we still have that screw kit. It is the Replacement Jack Screw and Nut Kit for Bulldog Sidewind Trailer Jacks item #BD500217. This is designed to fit Bulldog series 182 jacks from 2003 to present with a 12,000 lb capacity. I have linked a…

Hey John, the replacement gear kit you'd need is the part #TJD-12000-RODNUT which I attached two pictures that have instructions and an install diagram.

I went ahead and reached out to RAM and they explained to me that to re-install your inner leg to your RAM jack like the Square Direct Weld Jack - Drop Leg w/ Spring Return #TJD-12000SP-R2NH, you are going to need to re-install the lower pin, replace…

The correct way to wire your breakaway battery, like the Hopkins Engager #20400, is to have the black wire from the battery connected to the 12V power on your trailer, and then the blue wire to your breakaway switch which, in turn, connects to the…

We have several replacement parts for the internals of a Ram brand square jack. The Replacement Rod and Nut #TJD-12000-RODNUT will fit the following Ram jacks: #TJD-12000SP-F2 10K Sidewind with 12-3/8 inches of travel w/handle #TJD-12000SP-R2NH 10K…

The portion you need to measure is not the cap, but the the hub bore. Remove the grease caps and measure the diameter of the opening the caps occupy. This is the hub bore. You will need an accurate measuring devices like a set of dial calipers that…

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…