An In-Depth Look at the Master Lock Hitch Receiver and Coupler Latch Lock Set Video

Yes, the Curt weight distribution shank part #17120 is a fit with the Fastway E2 WD system part #FA92-02-4100 that you referenced. Thankfully nearly all of the weight distribution system manufacturers made their head and shank dimensions similar.

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

Hey Steve, Dexstar trailer wheels are made in the USA so for one that is 15 inch by 6 inch wide we have the part #AM20545

Yes, you can splice into the tailgate handle lock/unlock wires if equipped when installing the Pop & Lock Power Locking Handle for Truck Caps and Hard Tonneau Covers part #PAL9555. The provided instructions are used when there is no locking…

Hello Fillip, Good afternoon to you as well. I was able to get out to the warehouse to get that measurement. On the Benton LittleShift Bike Rack for 1 Bike #B54VR from the hitch pin to the furthest part of the rack is 22". You can compare this…

Hey Audrey, To replace your Ventline VD0434 Roof Vent screen and frame you would need the Replacement Screen Frame with Screen for Ventline Ventadome Manual Lift Roof Vents #BVC0573-31. This comes in birch white to match your vent's color.

From the center of the hitch pin hole to the top of that small vertical post at the end of the shank on the RockyMounts BackStage #RKY10002 there is a distance of 4-3/8 inches. I have attached an image to assist. You can use this measurement to…

It is not recommended to invert the Malone 2" Dual Purpose Hitch Receiver #MPG544 for towing purposes. The extended receiver is only intended for accessory use not for a ball mount and trailer connection. Your trailer hitch's tongue weight…

Though this technically will work when looking at all the measurements, I cannot recommend doing so. Here's my reasoning behind saying that. With your fully loaded trailer having a tongue weight of 315 pounds and your loaded bike rack weighing 50…

I may have a solution for you on this, but the short answer to this is- no. Stabilizer jacks and auto-leveling systems have two fairly different functions and the PSX2 system is not going to be able to function as an auto-leveling system with any…

The Curt Trailer Hitch Receiver #C11550 is designed for a 2019-2021 Hyundai Veloster unless it is the N model. Since Hyundai is only making the N model starting with the 2022 model year we still have yet to see a hitch designed to fit this vehicle,…

You will need to measure the diameter of the spindles where the seal and bearings ride. Check out the picture I attached that shows where this is. You will need an exact measurement so either a digital or dial caliper will be needed. To pick out the…