Gen-Y Anti-Rattle Clamp for 2" Hitch Receivers Feature Review Video

We have just what you're looking for with the Gen-Y Anti-Rattle Clamp for 2" Hitch Receivers #GY88XR. The sleeve acts as a wedge to take out play between your hitch receiver and extender. Although it does not not require a wrench and a…

According to the online version of the owner's manual for your 2010 Honda Fit that we found you will need to remove the Radio fuse from the interior fuse block which is in the 61 position. This is where you will want to install the Roadmaster…

Yes, there is a way to secure the accessories to the Yakima EXO Swing Away Cargo Carrier item #Y72VR. The Swing Away base has Yakima's Same Key System (SKS) locks built in that secures the accessories to the base. These cores are included but can…

That is a keen observation and a good question. I actually had the chance to assist with assembly of one of the Flint Hill Goods 30" x 50" Wheelchair Carriers #FHG99ZR not too long ago. The main bolt for the shank is indeed quite large, so…

I do have a solution for you, however the Draw-Tite QSP Trailer Hitch Silencer and Cover for 2" Hitch Receivers #63080 is specifically designed to work with Draw-Tite 2" x 2" trailer hitch receivers. Because the collars on the hitch…

The ride on the back of a trailer is very rough due to the extended distance from the axle so a lot of hitch mounted accessories like the Flint Hill Goods 30x50 Wheelchair Carrier part #FHG99ZR are not rated for this. Instead, I recommend using the…

It is very unlikely that the hitch pin hole on your Draw-Tite Trailer Hitch Receiver is worn causing the ball mount to slide back and forth. There is usually a little bit of play in the receiver tube opening with a ball mount and this can easily be…

The RockyMounts Hitch Extender LS #RKY10011 will absolutely work for you on your 2018 Toyota 4Runner based on the weights you gave. A hitch adapter, like an extender, reduces the overall capacity of your hitch by 50 percent. Since you mentioned your…

The Timbren Trailer Suspension Enhancement System #TTRA1702 is 2-3/4" tall with no load on the spring. This particular system is designed to mount to the frame with the included bracket(see image) and when the suspension compresses the axle will…

Not only does the Gen-Y Replacement Shank #325-GH-303 have the 10,000-lbs capacity (1500-lbs tongue weight) that you're looking for, it will provide you with a 5" rise or drop, depending on how you decide to use it. This hitch will work with…

The only Aluminum cargo carrier we currently carry close to 24" x 60" would be the 30x50 Curt Cargo Carrier #C18112. This cargo carrier only has a slight rise in the shank and comes with a 48-1/8" long folding ramp. The shank also…

The Big Bed load extender, part #EM07600, has three height settings in 1 inch increments. I went out to the warehouse and measured from the center of the hitch pin hole myself and they're about 17-1/8, 18/-1/8, and 19-1/8 inches to the top of the…