2025 GMC Sierra 2500 6-3/4 Foot Bed Tool Box

According to Blue Ox, it'll take an experienced installer about 4 to 5 hours to complete the installation of their #BX1128 Base Plate Kit on a 2016 Jeep Grand Cherokee. The install isn't what I'd call super-difficult, but the installation…

Thanks for the picture! I checked with Progressive Dynamics the replacement power converter you need for your Parallax Series 7300 Model 7345 is the Replacement Converter for Parallax/Magnetek or WFCO RV Power Centers - 45 Amp item #PD4645V.

Hey John congrats on the new truck! To add a set of air bags to your 2025 Ram 3500, I recommend the Air Lift LoadLifter 7500 XL Air Helper Springs item #AL57531. These fit both the 2WD and 4WD models and have a 7,500 lbs load leveling capacity. All…

Yes, the best option we can offer you to add fuel capacity is with the DeeZee Truck Bed Auxiliary Tank part #DZ91752X which should fit in the space you have between the cab and 5th wheel hitch no problem as it is only 9" deep. I don't have…

I do recommend using two pairs of the Ultra-Fab Chock and Lock Wheel Stabilizers #UF21-001070 for your triple axle trailer. Doing so is going to give you the best amount of stability to limit the front-to-back rocking motion that will occur when you…

Great question, Kevin. The Onboard Scale system on your 2024 Ford F-350 Super Duty works by essentially measuring how low the bed is sitting and it gives an estimated weight based off of that. If you added a suspension enhancement then that would…

Hey Paul, it looks like the OEM springs of your 2021 Ram 2500 are rated for 2,218 lbs per spring whereas the SumoSprings part #SSC-52 are rated for 2,475 lbs.

I have a solution for you but the Weather Guard Truck Tool Box #WG46ZV that you referenced is not a low profile box. It sits on top of the truck bed rails so it would not allow a tonneau cover to fit over it. It's also a wider box at 27-1/2…

The UWS Truck Bed Chest #UWS01047 doesn't come with any mounting hardware and doesn't actually have any holes predrilled into it for mounting so it would be a custom job to mount it. That being said you could just drill through the bottom of…

Hey Jerry, GM moved the placement of their puck systems starting with 2020 models so you are correct that the pucks would have the hitch not sit directly over the axle. GM did the math and made sure that this placement wouldn't adversely affect…

I recommend the UWS Truck Bed Toolbox w/ Pull Handles #UWS07646 to go with your Access Toolbox Edition Soft, Roll-Up Tonneau Cover #A61409. It is low profile, 14-1/2" tall to allow you some extra space for hauling material, and is 20" wide…

You will have to go with a sliding hitch to allow the trailer to make tight turns. For a trailer 8 feet wide the only bed length that's going to allow 90 degree turns without a slider is a stationary hitch. That being said you have two options.…