Expert Review Video:
Towing Mirrors Specs:
Features:
Durable mirror slides over the side-view mirror on the passenger's side of your vehicle to extend your line of sight while you're towing. Felt-covered wedge lock securely fastens the slip-on mirror in place. Tool-free installation.
Installation Notes:
Product does not fit full chrome mirrors
Tech Tip:
Does not fit SLT or Laramie models
More Information >Videos
for Towing Mirrors
Help Articles
for Towing Mirrors
Expert Answers
for Towing Mirrors
My contact at Yates Rubber advises that a nominal 8-inch keel roller does not measure exactly 8 inches; typically they are slightly smaller than the specified size, much the way a piece of 2 x 4 lumber is not exactly 2-inches by 4-inches. I took…
view full answer...I looked up pictures of the taillights that are on the 3110 Featherlite trailers and for the LED version of them you would want the part #STL36RB and #STL37RB. It looks like the spare tire mounts for your trailer are something you would have to get…
view full answer...The correct replacement for a Demco Master Cylinder 05680-C is the Replacement Master Cylinder part #5650. I spoke with Demco to confirm this for you.
view full answer...You will need the Red LED Trailer Clearance or Side Marker Light #328-K-52 or Amber LED Trailer Clearance or Side Marker Light #328-K-51 for your 2018 Forest River Sunseeker motorhome. These lenses have the same Top Command SAE-AP2-16 markings on…
view full answer...The correct replacement master cylinder kit we have for your Demco setup is the part #DM5918 which comes with the lock out replacement.
view full answer...Torque specs for wheel lug nuts will vary depending on the diameter of the lugs, type of lug nut and the wheel's material. The linked chart details the recommended torque for many…
view full answer...You will need the Ceiling Garnish for Fan-Tastic Vents Roof Vent #FVK1060-81 as it is specific to your Dometic Fantastic Fan 1450. The Ceiling Garnish for Ventline Roof Vent #VA0445-37 is going to have rounded corners as opposed to the square on…
view full answer...On single axle trailers typically you put the hanger spacing right at 1/4 of an inch shorter than the leaf spring length from eye to eye center. So if you were using the leaf spring part #e54SR that you referenced which measures 25-1/8 inches long…
view full answer...On a single axle trailer you will want to have a hanger spacing of around 22-3/4 inches when using the 23-1/8 inch long Double-Eye Spring #e59SR. This will allow that rear shackle to correctly lean away from the axle for proper suspension travel.
view full answer...Thank you for purchasing from etrailer! You did a great job selecting compatible parts. When using Leaf Springs #e64SR with the #AP233 Equalizer Kit and the #H248 Hanger Kit, there should be…
view full answer...Yes! What you're going to need for your 2022 Chevrolet 2500HD, is the 7-Way Vehicle Power Adapter w/ Power Switch for Furrion RV Observation Camera #FR87PR. This will plug directly…
view full answer...You can use the LED Light Bulb Load-Resistor Kit #DI34ZR on that camera power wire to draw the full 12V needed or you can use the Trailer Connector Adapter w/ Lamp-Out Sensor Bypass #20142 that has an integrated load-resistor for that function.
view full answer...