Videos
for Search Results
Help Articles
for Search Results
Expert Answers
for Search Results
Hey Tyler, thanks for reaching out. I'm sorry to say no, we don't have a 5 on 4-1/2" hub, or any hub for that matter that fits a 3/4" straight spindle. That kind of spindle was really only seen on older trailers and is basically…
view full answer...The best choice for replacing your Carrier RV Air Conditioner is the Advent Air Replacement RV Air Conditioner for Carrier Setup, #ACCAR150 for 13,500 Btu's or #ACCAR135 for 15,000 Btu's. This AC unit replaces the Carrier air conditioner on…
view full answer...In order to replace your Carrier Air V RV Air Conditioner I highly recommend using the Advent Air Replacement RV Air Conditioner for Carrier Setup part #ACCAR135 for 13,500 Btu's or part #ACCAR150 for 15,000 Btu's. This unit will be the only…
view full answer...Hey Matt, Furrion typically has 4 wires running to their thermostats and the Chill Cube Thermostat #LC74DX is no exception. The harness you see with the thermostat would plug into the Chill Cube's controller and has 4 wires to extra wire to to…
view full answer...Sounds like you have the Sportside with a non towing bumper which would mean you would want the part #75085. If instead you had the factory roll pan bumper you would want the pat #13920. I attached a picture of what the sportside with non-towing…
view full answer...In regards to the Starter Solenoid part #PK5230701, the larger terminals are for power in and out. The smaller terminals are for ignition/remote and ground. It does not matter which side goes where. The solenoid is designed to be mounted vertically,…
view full answer...That's a very good question, we tend to be extra cautious and say to use 10 gauge wire because that would be more than enough. When you get into longer trailers that will end up using a lot of wire the heavier gauge wire becomes more necessary.…
view full answer...There is not a standard plug available that would allow you to plug the Advent Air Rooftop RV Air Conditioner #ACM135 right to an extension cord. The unit will need to be hardwired using the included wiring and hardware. I have attached the complete…
view full answer...Hi Richard, I'm pretty sure they are the same thing, and the issue is mostly rounding (bear with me a second). The wheel studs that say they have a .54 generally have a .545. Technically, that should round up to .55, but not all do for one reason…
view full answer...The magnet clips #BP19005 should not be making contact with the drum while the brakes engage, so I do not think that is the problem. What I think is going on is it's just not seating all the way. These can get a little squished or deformed…
view full answer...In 2007, Chevrolet stopped offering plug-in connectors for brake controllers on their full size trucks with tow packages. Instead, you will have four or five blunt-cut wires bundled underneath your dash. The wire colors should be red with a black…
view full answer...Hello Jeff, Thanks for the pictures, they are most helpful! Yes, you will be able to install the Thetford Aqua-Magic Style II Part-Timer RV Toilet - Low Profile - Round Bowl - White Ceramic #TH35SE which is Thetford's part number 42053, so it is…
view full answer...