Result: trailer leveling

To convert the WFCO WF-8955PEC to be lithium compatible you'd need the part #PD4655V and you'd be set. This fits in the panel without any modifications.

Hi Mike; the Ark Drop Down Corner RV Stabilizer Jacks #ARK77FR can be used in three different positions. At 30° and 60° they act as non-rated stabilizers. At 90° they have the 1,929 lb rating.

We do carry the 33" Ark Stabilizer Jack that you are looking for with part #ARK77FR. I was able to track down a few drawings that you should find helpful. These are for the 30" #ARK94FR and the 24" #ARK34FR Stabilizer jacks. I'm…

Your math is correct in your trailer weight load example. If a fully-loaded tandem axle trailer weighs 4000-lbs then each of the 4 tires will bear 1/4th of that load, or 1000-lbs. In this case a tire rated for 1300-lbs would provide a good safety…

The Stromberg Carlson #JET-5000 is covered by a 2-year warranty. If you purchased it from us, you won't need to do anything as we have you in our system. If you purchased it elsewhere, you'll need to check with that retailer to determine what…

The Scissor Stabilizer Jack #TJSC-24, which also comes in a 2-pack #TJSCHD-24 and a 4-pack #TJSCHD-24-4, is a universal fit so you would need to double check our measurements to ensure they fit your travel trailer. When they are collapsed they…

The Electric Jack part #EJ-3520-BBX is what I recommend using as it's an excellent economical upgrade option. If you are replacing an exiting electric jack then just run the power wire to the battery, secure the flange to the frame, and…

I am sorry to hear about the functional issues you are having with your Stromberg Carlson Electric Trailer Jack #JET-3755. Based on the issue you are describing I would first manually lower the jack a little bit to make sure it was not overextended.…

The Roadmaster Quiet Hitch, #RM-062, does fit 2-1/2 inch receivers like the one on your 2009 Chevy Silverado 2500 but it is made for flat towing only (towing a vehicle behind a motor home) and is not rated for towing. Towing a trailer produces more…

You do not have to use a sliding 5th wheel hitch in a short bed truck. In many cases, truck beds shorter than 8 ft do not have enough clearance between the trailer and truck to execute sharp turns. This is why sliding hitches were invented. Due to…

It sounds like you either have a lose connection or a just a bad controller. I would start by ensuring your wires are making full contact in the controller and the motor and that you don't have any cuts or damage in the wires along the way that…

The Replacement Ball and Plate Assembly for Curt Friction Sway Control System part #C17201 is the replacement ball and plate for the Curt Friction Sway Control for Weight Distribution Systems part #17200. The plate assembly needs to be 24"…