Videos
for Search Results
Help Articles
for Search Results
Expert Answers
for Search Results
The factory brake controller connector on your 2021 Jeep Grand Cherokee is located under the dash behind the hood latch, as shown in the provided photo. Keep in mind, the connector will only be there if the vehicle has the factory tow package which…
view full answer...Hey Thomas, if your Kar Kaddy already has brakes you'd need to use Demco's Replacement Brake Caliper Assembly for Demco Tow Dollies #DM13825-92 for a replacement. If your Kar Kaddy does not have brakes, then yes you can absolutely use the…
view full answer...The replacement I recommend for an Atwood Surge Brake Actuator 85778 is the Demco Hydraulic Brake Actuator part #DM62VR. It has the same ball size, offers a bolt-on install, and has a greater capacity. The only difference is it has an electric…
view full answer...Yes, you can! The DeeMaxx Rotors like the item #DE47VR are capable of being swapped out for Kodiak brake rotors. They are compatible with their calipers.
view full answer...Yes, and no but I have one that'll do both. The Master Lock Trailer Coupler Lock item #ML389DAT you were looking at will fit a Demco A-Frame Coupler with EZ Latch item #12660-97SP but not gooseneck couplers. For a coupler lock that does both…
view full answer...Thanks for the picture of the coupler of your rental trailer. Based on that we know it's a Demco EZ latch so for a lock that will work great securing it to your hitch ball we know the etrailer coupler lock part #e98887 would work well. It fits…
view full answer...The Bearing #29749 has a 1.5 inch inner diameter and the #LM67048 has a 1.250 inch inner diameter. I was able to find the complete assembly for you as Complete Agricultural Hub Assembly #AH30660FCOMP.
view full answer...Bearing measurements need to be as accurate as possible, to at least the thousandth of an inch, and require calipers if you have to measure them. Otherwise look at the bearing numbers that are stamped into the sides of the bearings. With those…
view full answer...The correct trailer hub to use with the Agricultural Spindle part #TRU67FR is the Trailer Hub Assembly part #AH60880FCOMP which features an 8 on 8" bolt pattern. The Dexter Trailer Idler Hub Assembly part #42660UC1 will not fit the Agricultural…
view full answer...We do have a few idler hub assemblies with threaded lug bolt holes currently available, such as the Redline Complete Agricultural Hub Assembly #AH30660FCOMP. This hub has a 6 on 6 bolt pattern and will fit Spindle #TRU34FR. It has an inner bearing…
view full answer...You'll have to pull the hub off and either get me the dimensions of the spindle where the bearings ride or the bearing numbers out of the hub to determine if we have something that will fit. You'll need a caliper to do this. If you get back…
view full answer...The Complete Agricultural Hub Assembly for Spindle AS3000F #AH30660FCOMP has threaded bolt holes for the 1/2 inch Lug bolts that come with the hub. We don't have any that are the same 6 on 6 inch bolt pattern with lug studs, but the lug bolts…
view full answer...