Result: m101a2

I wish I could say for sure that the #AKHD-655-6-EZ-K fits but we don't have that information. You will have to identify the bearings on your M101A2 to confirm this. The hub assembly uses the #25580 inner bearing and #15123 outer bearing so if…

If the military trailer you are looking at has a lunette ring coupler for attaching to a pintle the part #C48205 would do a great job as long as the total weight of the trailer loaded was less than 10k. Let's say you need more capacity than that…

It is possible to install electric trailer brakes or an electric-over-hydraulic (EOH) braking system on a trailer that has surge brakes, like your M101A3 single-axle trailer. Installing electric drum brakes will be simpler and less costly that going…

It sounds like you are speaking of the wires for the brake magnets. If this is correct, you will need to connect one of the wires to the brake controller output wire on your trailer connector and the other wire will need to be grounded to a clean…

I would use a protractor, see photo, place the protractor on the edge of the inside of one side of the trailer frame and the other inside edge of the trailer frame should be parallel with the 50 degree line on the protractor. Another way to verify…

The etrailer A-Frame Trailer Coupler w/ Round Jack Hole #CA-5280-RB uses the standard a-frame angle of 50 degrees. The length from the rear of the coupler to where the coupler meets its narrowest point is approximately 9" long. I have include…